In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_fib: fix stale stack leak via the OIFNAME register
For NFT_FIB_RESULT_OIFNAME the destination register is declared with
len = IFNAMSIZ (four 32-bit registers), but on the lookup-fail,
RTN_LOCAL and oif-mismatch paths nft_fib{4,6}_eval() only writes one
register via "*dest = 0". The remaining three registers are left as
whatever was on the stack in nft_do_chain()'s struct nft_regs, and a
downstream expression that loads the register span can leak that
uninitialised kernel stack to userspace.
The NFTA_FIB_F_PRESENT existence check has the same shape: it is only
meaningful for NFT_FIB_RESULT_OIF, yet it was accepted for any result type
while the eval stores a single byte via nft_reg_store8(), leaving the rest
of the declared span stale.
Fix both:
- replace the bare "*dest = 0" in the eval with nft_fib_store_result(),
which strscpy_pad()s the whole IFNAMSIZ for OIFNAME (and is already
used on the other early-return path), and
- restrict NFTA_FIB_F_PRESENT to NFT_FIB_RESULT_OIF and declare its
destination as a single u8, so the marked span matches the one byte
the eval writes.
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Fix NULL deref and buffer over-read in SDP debugfs
[Why & How]
dp_sdp_message_debugfs_write() dereferences connector->base.state->crtc
without checking for NULL. A connector can be connected but not bound to
any CRTC (e.g. after hot-plug before the next atomic commit), causing a
kernel crash when writing to the sdp_message debugfs node.
The function also ignores the user-provided size argument and always
passes 36 bytes to copy_from_user(), reading past the user buffer when
size < 36.
Fix both issues by:
- Returning -ENODEV when connector->base.state or state->crtc is NULL
- Clamping write_size to min(size, sizeof(data))
(cherry picked from commit 6ab4c36a522842ff70474a1c0af2e40e50fc8300)
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Clamp VBIOS HDMI retimer register count to array size
[Why & How]
The VBIOS integrated info tables (v1_11 and v2_1) contain HdmiRegNum and
Hdmi6GRegNum fields that are used as loop bounds when copying retimer I2C
register settings into fixed-size arrays (dp*_ext_hdmi_reg_settings[9]
and dp*_ext_hdmi_6g_reg_settings[3]). These u8 fields are not validated
before use, so a malformed VBIOS can specify values up to 255, causing an
out-of-bounds heap write during driver probe.
Clamp each register count to the destination array size using min_t()
before the copy loops, in both get_integrated_info_v11() and
get_integrated_info_v2_1().
(cherry picked from commit 5a7f0ef90195940c54b0f5bb85b87da55f038c69)
In the Linux kernel, the following vulnerability has been resolved:
drbd: Balance RCU calls in drbd_adm_dump_devices()
Make drbd_adm_dump_devices() call rcu_read_lock() before
rcu_read_unlock() is called. This has been detected by the Clang
thread-safety analyzer.
In the Linux kernel, the following vulnerability has been resolved:
fs/mbcache: cancel shrink work before destroying the cache
mb_cache_destroy() calls shrinker_free() and then frees all cache
entries and the cache itself, but it does not cancel the pending
c_shrink_work work item first.
If mb_cache_entry_create() schedules c_shrink_work via schedule_work()
and the work item is still pending or running when mb_cache_destroy()
runs, mb_cache_shrink_worker() will access the cache after its memory
has been freed, causing a use-after-free.
This is only reachable by a privileged user (root or CAP_SYS_ADMIN)
who can trigger the last put of a mounted ext2/ext4/ocfs2 filesystem.
Cancel the work item with cancel_work_sync() before calling
shrinker_free(), ensuring the worker has finished and will not be
rescheduled before the cache is torn down.
In the Linux kernel, the following vulnerability has been resolved:
fs/omfs: reject s_sys_blocksize smaller than OMFS_DIR_START
omfs_fill_super() rejects oversized s_sys_blocksize values (> PAGE_SIZE),
but it does not reject values smaller than OMFS_DIR_START (0x1b8 = 440).
Later, omfs_make_empty() uses
sbi->s_sys_blocksize - OMFS_DIR_START
as the length argument to memset(). Since s_sys_blocksize is u32,
a crafted filesystem image with s_sys_blocksize < OMFS_DIR_START causes
an unsigned underflow there, wrapping to a value near 2^32. That drives
a ~4 GiB memset() from bh->b_data + OMFS_DIR_START and overwrites kernel
memory far beyond the backing block buffer.
Add the corresponding lower-bound check alongside the existing upper-bound
check in omfs_fill_super(), so that malformed images are rejected during
superblock validation before any filesystem data is processed.
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: fix locking in hci_conn_request_evt() with HCI_PROTO_DEFER
When protocol sets HCI_PROTO_DEFER, hci_conn_request_evt() calls
hci_connect_cfm(conn) without hdev->lock. Generally hci_connect_cfm()
assumes it is held, and if conn is deleted concurrently -> UAF.
Only SCO and ISO set HCI_PROTO_DEFER and only for defer setup listen,
and HCI_EV_CONN_REQUEST is not generated for ISO. In the non-deferred
listening socket code paths, hci_connect_cfm(conn) is called with
hdev->lock held.
Fix by holding the lock.
In the Linux kernel, the following vulnerability has been resolved:
bpf: reject short IPv4/IPv6 inputs in bpf_prog_test_run_skb
bpf_prog_test_run_skb() calls eth_type_trans() first and then uses
skb->protocol to initialize sk family and address fields for the test
run.
For IPv4 and IPv6 packets, it may access ip_hdr(skb) or ipv6_hdr(skb)
even when the provided test input only contains an Ethernet header.
Reject the input earlier if the Ethernet frame carries IPv4/IPv6
EtherType but the L3 header is too short.
Fold the IPv4/IPv6 header length checks into the existing protocol
switch and return -EINVAL before accessing the network headers.
In the Linux kernel, the following vulnerability has been resolved:
ppp: require CAP_NET_ADMIN in target netns for unattached ioctls
/dev/ppp open is currently authorized against file->f_cred->user_ns,
while unattached administrative ioctls operate on current->nsproxy->net_ns.
As a result, a local unprivileged user can create a new user namespace
with CLONE_NEWUSER, gain CAP_NET_ADMIN only in that new user namespace,
and still issue PPPIOCNEWUNIT, PPPIOCATTACH, or PPPIOCATTCHAN against
an inherited network namespace.
Require CAP_NET_ADMIN in the user namespace that owns the target network
namespace before handling unattached PPP administrative ioctls.
This preserves normal pppd operation in the network namespace it is
actually privileged in, while rejecting the userns-only inherited-netns
case.
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix OOB in pcpu_init_value
An out-of-bounds read occurs when copying element from a
BPF_MAP_TYPE_CGROUP_STORAGE map to another pcpu map with the
same value_size that is not rounded up to 8 bytes.
The issue happens when:
1. A CGROUP_STORAGE map is created with value_size not aligned to
8 bytes (e.g., 4 bytes)
2. A pcpu map is created with the same value_size (e.g., 4 bytes)
3. Update element in 2 with data in 1
pcpu_init_value assumes that all sources are rounded up to 8 bytes,
and invokes copy_map_value_long to make a data copy, However, the
assumption doesn't stand since there are some cases where the source
may not be rounded up to 8 bytes, e.g., CGROUP_STORAGE, skb->data.
the verifier verifies exactly the size that the source claims, not
the size rounded up to 8 bytes by kernel, an OOB happens when the
source has only 4 bytes while the copy size(4) is rounded up to 8.