Linux: >> Linux Kernel >> 5.4.225 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
RDMA/siw: Reject MPA FPDU length underflow before signed receive math
A malicious connected siw peer can send an iWARP FPDU whose MPA length
field (c_hdr->mpa_len, 16 bit big-endian, peer-controlled) is smaller
than the fixed DDP/RDMAP header for the announced opcode. Soft-iWARP
parses the full header in siw_get_hdr() based on iwarp_pktinfo[opcode]
.hdr_len, but never compares mpa_len against that header length.
siw_tcp_rx_data() then derives
srx->fpdu_part_rem = be16_to_cpu(mpa_len) - fpdu_part_rcvd
+ MPA_HDR_SIZE;
where fpdu_part_rcvd equals iwarp_pktinfo[opcode].hdr_len at this
point. For a tagged WRITE (hdr_len 16, MPA_HDR_SIZE 2) the smallest
on-wire mpa_len of 0 yields fpdu_part_rem = -14, and any mpa_len below
hdr_len - MPA_HDR_SIZE underflows to a negative int.
The signed value then flows into siw_proc_write()/siw_proc_rresp() as
bytes = min(srx->fpdu_part_rem, srx->skb_new);
is handed to siw_check_mem() as an int len (whose interval check
addr + len > mem->va + mem->len is satisfied for a valid base when
len is negative), and reaches siw_rx_data() -> siw_rx_kva() /
siw_rx_umem() -> skb_copy_bits() as a signed copy length. The header
copy branch in skb_copy_bits() promotes that to size_t, producing a
multi-gigabyte read.
KASAN under a KUnit harness that drives the real kernel TCP receive
path -- a loopback AF_INET socketpair, the malformed FPDU written via
kernel_sendmsg, sk_data_ready firing in softirq, tcp_read_sock
dispatching to siw_tcp_rx_data -- reports:
BUG: KASAN: use-after-free in skb_copy_bits+0x284/0x480
Read of size 4294967295 at addr ffff888...
Call Trace:
skb_copy_bits
siw_rx_kva
siw_rx_data
siw_check_mem
siw_proc_write
siw_tcp_rx_data
__tcp_read_sock
siw_qp_llp_data_ready
tcp_data_ready
tcp_data_queue
Add the missing invariant at the earliest point where the peer header
is fully assembled. iwarp_pktinfo[*].hdr_len - MPA_HDR_SIZE is exactly
the value the siw transmitter uses as the minimum mpa_len for each
opcode (drivers/infiniband/sw/siw/siw_qp.c:33), so this matches the
protocol contract. Out-of-range FPDUs terminate the connection with
TERM_ERROR_LAYER_LLP / LLP_ETYPE_MPA / LLP_ECODE_FPDU_START -- which
is RFC 5044 Section 8 error code 3 ("Marker and ULPDU Length fields
do not agree on the start of an FPDU"), the correct framing-error
class for this inconsistency.
CVSS Score
9.8
EPSS Score
0.005
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
scsi: isci: Fix use-after-free in device removal path
The ISCI completion tasklet is initialized in isci_host_alloc()
(drivers/scsi/isci/init.c:496) and scheduled from both MSI-X and legacy
interrupt handlers (drivers/scsi/isci/host.c:223,613).
isci_host_deinit() stops the controller and waits for stop completion,
but it never kills completion_tasklet before teardown continues. A
top-of-function tasklet_kill() is not sufficient here: interrupts are
only disabled when isci_host_stop_complete() runs, so until
wait_for_stop() returns the IRQ handlers can still requeue the
tasklet. The tasklet callback also re-enables interrupts after draining
completions, so killing the tasklet before the source is quiesced leaves
the same race open.
Once wait_for_stop() returns, no further IRQ-driven scheduling can
occur. Kill completion_tasklet there so teardown cannot race a queued
tasklet running on a dead ihost. On remove or unload, the stale callback
can otherwise dereference ihost and touch ihost->smu_registers after the
host lifetime ends.
A UML + KASAN analogue reproduced the failure class both with no
tasklet_kill() and with tasklet_kill() placed before source quiesce, and
stayed clean once the kill happened after quiescing the scheduling
source.
This mirrors commit f6ab594672d4 ("scsi: aic94xx: fix use-after-free in
device removal path"), but ISCI needs the kill after wait_for_stop().
CVSS Score
7.8
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: vgic-its: Reject restored DTE with out-of-range num_eventid_bits
Userspace can restore an ITS Device Table Entry whose Size field encodes
more EventID bits than the virtual ITS supports. The live MAPD path
rejects that state, but vgic_its_restore_dte() accepts it and stores the
out-of-range value in dev->num_eventid_bits.
Reject restored DTEs with num_eventid_bits > VITS_TYPER_IDBITS before
allocating the device. This mirrors the MAPD check and prevents the
restored state from reaching vgic_its_restore_itt(), where the unchecked
value can be converted into an oversized scan_its_table() range.
CVSS Score
9.0
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tp_meter: directly shut down timer on cleanup
batadv_tp_sender_cleanup() was calling timer_delete_sync() followed by
timer_delete() to guard against the timer handler re-arming itself between
the two calls. This double-deletion hack relied on the sending status being
set to 0 to suppress re-arming.
Replace both calls with a single timer_shutdown_sync(). This function both
waits for any running timer callback to complete (like timer_delete_sync())
and permanently disarms the timer so it cannot be re-armed afterwards,
making re-arming prevention unconditional and self-documenting.
The re-arming property is also required because otherwise:
1. context 0 (batadv_tp_recv_ack()) checks in
batadv_tp_reset_sender_timer() if sending is still 1 -> it is
2. context 1 changes in batadv_tp_sender_shutdown() sending to 0 and in
this process forces the kthread to stop timer in
batadv_tp_sender_cleanup()
3. context 0 continues in batadv_tp_reset_sender_timer() and rearms the
timer -> but the reference for it is already gone
CVSS Score
8.8
EPSS Score
0.003
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: bla: avoid NULL-ptr deref for claim via dropped interface
Without rtnl_lock held, a hardif might be retrieved as primary interface of
a meshif, but then (while operating on this interface) getting decoupled
from the mesh interface. In this case, the meshif still exists but the
pointer from the primary hardif to the meshif is set to NULL.
The mesh_iface must be checked first to be non-NULL before continuing to
send an ARP request using meshif.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: bla: avoid double decrement of bla.num_requests
The bla.num_requests is increased when no request_sent was in progress. And
it is decremented in various places (announcement was received, backbone is
purged, periodic work). But the check if the request_sent is actually set
to a specific state and the atomic_dec/_inc are not safe because they are
not atomic (TOCTOU) and multiple such code portions can run concurrently.
At the same time, it is necessary to modify request_sent (state) and
bla.num_requests atomically. Otherwise batadv_bla_send_request() might set
request_sent to 1 and is interrupted. batadv_handle_announce() can then
set request_sent back to 0 and decrement num_requests before
batadv_bla_send_request() incremented it.
The two operations must therefore be locked. And since state (request_sent)
and wait_periods are only accessed inside this lock, they can be converted
to simpler datatypes. And to avoid that the bla.num_requests is touched by
a parallel running context with a valid backbone_gw reference after
batadv_bla_purge_backbone_gw() ran, a third state "stopped" is required to
correctly signal that a backbone_gw is in the state of being cleaned up.
CVSS Score
7.1
EPSS Score
0.003
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: mcast: fix use-after-free in orig_node RCU release
batadv_mcast_purge_orig() removes entries from RCU-protected hlists but
does not wait for an RCU grace period before returning. Concurrent RCU
readers may still accesses references to those entries at the point of
removal. RCU-protected readers trying to operate on entries like
orig->mcast_want_all_ipv6_node will then access already freed memory.
Fix this by moving batadv_mcast_purge_orig() to batadv_orig_node_release(),
just before the call_rcu() invocation. This ensures RCU readers that were
active at purge time have drained before the orig_node memory is reclaimed.
CVSS Score
8.8
EPSS Score
0.003
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Validate GPIO pin LUT table size before iterating
[Why&How]
The GPIO pin table parsers in get_gpio_i2c_info() and
bios_parser_get_gpio_pin_info() derive an element count from the VBIOS
table_header.structuresize field, then iterate over gpio_pin[] entries.
However, GET_IMAGE() only validates that the table header itself fits
within the BIOS image. If the VBIOS reports a structuresize larger than
the actual mapped data, the loop reads past the end of the BIOS image,
causing an out-of-bounds read.
Fix this by calling bios_get_image() to validate that the full claimed
structuresize is accessible within the BIOS image before entering the
loop in both functions.
(cherry picked from commit ba5e95b43b773ae1bf1f66ee6b31eb774e65afe3)
CVSS Score
7.8
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: fix negative tt_buff_len
batadv_orig_node::tt_buff_len was declared as s16, but the field is never
intended to hold a negative value. When a value greater than 32767 is
assigned, it wraps to a negative signed integer.
In batadv_send_other_tt_response(), tt_buff_len is temporarily widened to
s32. The incorrectly negative s16 value propagates into the s32, causing
batadv_tt_prepare_tvlv_global_data() to allocate a full sized buffer but
populates only a small portion of it with the collected changeset. All
remaining bits are kept uninitialized.
Using an u16 avoids this type confusion and ensures that no (negative) sign
extension is performed in batadv_send_other_tt_response().
CVSS Score
8.8
EPSS Score
0.003
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tt: fix negative last_changeset_len
batadv_piv_tt::last_changeset_len len was declared as s16, but the field is
never intended to hold a negative value. When a value greater than 32767 is
assigned, it wraps to a negative signed integer.
In batadv_send_my_tt_response(), last_changeset_len is temporarily widened
to s32. The incorrectly negative s16 value propagates into the s32, causing
batadv_tt_prepare_tvlv_local_data() to allocate a full sized buffer but
populates only a small portion of it with the collected changeset. All
remaining bits are kept uninitialized.
Using an u16 avoids this type confusion and ensures that no (negative) sign
extension is performed in batadv_send_my_tt_response().
CVSS Score
9.8
EPSS Score
0.006
Published
2026-07-19