In the Linux kernel, the following vulnerability has been resolved:
batman-adv: clear current gateway during teardown
batadv_gw_node_free() removes the gateway list entries during mesh teardown,
but it does not clear the currently selected gateway. This leaves stale
gateway state behind across cleanup and can break a later mesh recreation.
Clear bat_priv->gw.curr_gw before walking the gateway list so the selected
gateway reference is dropped as part of teardown.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: ebtables: fix OOB read in compat_mtw_from_user
Luxiao Xu says:
The function compat_mtw_from_user() converts ebtables extensions from
32-bit user structures to kernel native structures. However, it lacks
proper validation of the user-supplied match_size/target_size.
When certain extensions are processed, the kernel-side translation
logic may perform memory accesses based on the extension's expected
size. If the user provides a size smaller than what the extension
requires, it results in an out-of-bounds read as reported by KASAN.
This fix introduces a check to ensure match_size is at least as large
as the extension's required compatsize. This covers matches, watchers,
and targets, while maintaining compatibility with standard targets.
AFAIU this is relevant for matches that need to go though
match->compat_from_user() call. Those that use plain memcpy with the
user-provided size are ok because the caller checks that size vs the
start of the next rule entry offset (which itself is checked vs. total
size copied from userspace).
The ->compat_from_user() callbacks assume they can read compatsize bytes,
so they need this extra check.
Based on an earlier patch from Luxiao Xu.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: ip6t_hbh: reject oversized option lists
struct ip6t_opts stores at most IP6T_OPTS_OPTSNR option descriptors,
but hbh_mt6_check() does not reject larger optsnr values supplied from
userspace.
Validate optsnr in the rule setup path so only match data that fits the
fixed-size opts array can be installed. This follows the existing xtables
pattern of rejecting invalid user-provided counts in checkentry() and
keeps the packet matching path unchanged.
`struct ip6t_opts` has a fixed `opts[IP6T_OPTS_OPTSNR]` array,
where `IP6T_OPTS_OPTSNR` is 16, then off-by-one array access is possible:
[ 137.924693][ T8692] UBSAN: array-index-out-of-bounds in ../net/ipv6/netfilter/ip6t_hbh.c:110:29
[ 137.926167][ T8692] index 16 is out of range for type '__u16 [16]'
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: serialize accept_q access
bt_sock_poll() walks the accept queue without synchronization, while
child teardown can unlink the same socket and drop its last reference.
The unsynchronized accept queue walk has existed since the initial
Bluetooth import.
Protect accept_q with a dedicated lock for queue updates and polling.
Also rework bt_accept_dequeue() to take temporary child references under
the queue lock before dropping it and locking the child socket.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_policy: fix strict mode inbound policy matching
match_policy_in() walks sec_path entries from the last transform to the
first one, but strict policy matching needs to consume info->pol[] in
the same forward order as the rule layout.
Derive the strict-match policy position from the number of transforms
already consumed so that multi-element inbound rules are matched
consistently.
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath5k: do not access array OOB
Vincent reports:
> The ath5k driver seems to do an array-index-out-of-bounds access as
> shown by the UBSAN kernel message:
> UBSAN: array-index-out-of-bounds in drivers/net/wireless/ath/ath5k/base.c:1741:20
> index 4 is out of range for type 'ieee80211_tx_rate [4]'
> ...
> Call Trace:
> <TASK>
> dump_stack_lvl+0x5d/0x80
> ubsan_epilogue+0x5/0x2b
> __ubsan_handle_out_of_bounds.cold+0x46/0x4b
> ath5k_tasklet_tx+0x4e0/0x560 [ath5k]
> tasklet_action_common+0xb5/0x1c0
It is real. 'ts->ts_final_idx' can be 3 on 5212, so:
info->status.rates[ts->ts_final_idx + 1].idx = -1;
with the array defined as:
struct ieee80211_tx_rate rates[IEEE80211_TX_MAX_RATES];
while the size is:
#define IEEE80211_TX_MAX_RATES 4
is indeed bogus.
Set this 'idx = -1' sentinel only if the array index is less than the
array size. As mac80211 will not look at rates beyond the size
(IEEE80211_TX_MAX_RATES).
Note: The effect of the OOB write is negligible. It just overwrites the
next member of info->status, i.e. ack_signal.
In the Linux kernel, the following vulnerability has been resolved:
spi: topcliff-pch: fix use-after-free on unbind
Give the driver a chance to flush its queue before releasing the DMA
buffers on driver unbind
In the Linux kernel, the following vulnerability has been resolved:
selinux: allow multiple opens of /sys/fs/selinux/policy
Currently there can only be a single open of /sys/fs/selinux/policy at
any time. This allows any process to block any other process from
reading the kernel policy. The original motivation seems to have been
a mix of preventing an inconsistent view of the policy size and
preventing userspace from allocating kernel memory without bound, but
this is arguably equally bad. Eliminate the policy_opened flag and
shrink the critical section that the policy mutex is held. While we
are making changes here, drop a couple of extraneous BUG_ONs.
In the Linux kernel, the following vulnerability has been resolved:
isofs: validate Rock Ridge CE continuation extent against volume size
rock_continue() reads rs->cont_extent verbatim from the Rock Ridge CE
record and passes it to sb_bread() without checking that the block
number is within the mounted ISO 9660 volume. commit e595447e177b
("[PATCH] rock.c: handle corrupted directories") added cont_offset
and cont_size rejection for the CE continuation but did not validate
the extent block number itself. commit f54e18f1b831 ("isofs: Fix
infinite looping over CE entries") later capped the CE chain length
at RR_MAX_CE_ENTRIES = 32 but again left the block number unchecked.
With a crafted ISO mounted via udisks2 (desktop optical auto-mount)
or via CAP_SYS_ADMIN mount, rs->cont_extent can therefore point at
an out-of-range block or at blocks belonging to an adjacent
filesystem on the same block device. sb_bread() on an out-of-range
block returns NULL cleanly via the block layer EIO path, so there
is no memory-safety violation. For in-range reads of adjacent-
filesystem data, the CE buffer is parsed as Rock Ridge records and
only the text of SL sub-records reaches userspace through
readlink(), which makes the info-leak channel narrow and difficult
to exploit; still, rejecting the malformed CE outright matches the
rejection shape already present in the same function for
cont_offset and cont_size.
Add an ISOFS_SB(sb)->s_nzones bounds check to rock_continue() next
to the existing offset/size rejection, printing the same
corrupted-directory-entry notice.