Linux: >> Linux Kernel >> 5.14.3 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
drm/sun4i: backend: fix error pointer dereference
The function drm_atomic_get_plane_state() can return an error pointer
and is not checked for it. Add error pointer check.
Detected by Smatch:
drivers/gpu/drm/sun4i/sun4i_backend.c:496 sun4i_backend_atomic_check() error:
'plane_state' dereferencing possible ERR_PTR()
CVSS Score
5.5
EPSS Score
0.002
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
drm/komeda: fix integer overflow in AFBC framebuffer size check
The AFBC framebuffer size validation calculates the minimum required
buffer size by adding the AFBC payload size to the framebuffer offset.
This addition is performed without checking for integer overflow.
If the addition oveflows, the size check may incorrectly succed and
allow userspace to provide an undersized drm_gem_object, potentially
leading to out-of-bounds memory access.
Add usage of check_add_overflow() to safely compute the minimum
required size and reject the framebuffer if an overflow is detected.
This makes the AFBC size validation more robust against malformed.
Found by Linux Verification Center (linuxtesting.org) with SVACE.
CVSS Score
7.1
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
dm log: fix out-of-bounds write due to region_count overflow
The local variable region_count in create_log_context() is declared as
unsigned int (32-bit), but dm_sector_div_up() returns sector_t (64-bit).
When a device-mapper target has a sufficiently large ti->len with a small
region_size, the division result can exceed UINT_MAX. The truncated
value is then used to calculate bitset_size, causing clean_bits,
sync_bits, and recovering_bits to be allocated far smaller than needed
for the actual number of regions.
Subsequent log operations (log_set_bit, log_clear_bit, log_test_bit) use
region indices derived from the full untruncated region space, causing
out-of-bounds writes to kernel heap memory allocated by vmalloc.
This can be reproduced by creating a mirror target whose region_count
overflows 32 bits:
dmsetup create bigzero --table '0 8589934594 zero'
dmsetup create mymirror --table '0 8589934594 mirror \
core 2 2 nosync 2 /dev/mapper/bigzero 0 \
/dev/mapper/bigzero 0'
The status output confirms the truncation (sync_count=1 instead of
4294967297, because 0x100000001 was truncated to 1):
$ dmsetup status mymirror
0 8589934594 mirror 2 254:1 254:1 1/4294967297 ...
This leads to a kernel crash in core_in_sync:
BUG: scheduling while atomic: (udev-worker)/9150/0x00000000
RIP: 0010:core_in_sync+0x14/0x30 [dm_log]
CR2: 0000000000000008
Fixing recursive fault but reboot is needed!
Fix by widening the local region_count to sector_t and adding an
explicit overflow check before the value is assigned to lc->region_count.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
dm cache: fix dirty mapping checking in passthrough mode switching
As mentioned in commit 9b1cc9f251af ("dm cache: share cache-metadata
object across inactive and active DM tables"), dm-cache assumed table
reload occurs after suspension, while LVM's table preload breaks this
assumption. The dirty mapping check for passthrough mode was designed
around this assumption and is performed during table creation, causing
the check to fail with preload while metadata updates are ongoing. This
risks loading dirty mappings into passthrough mode, resulting in data
loss.
Reproduce steps:
1. Create a writeback cache with zero migration_threshold to produce
dirty mappings
dmsetup create cmeta --table "0 8192 linear /dev/sdc 0"
dmsetup create cdata --table "0 131072 linear /dev/sdc 8192"
dmsetup create corig --table "0 262144 linear /dev/sdc 262144"
dd if=/dev/zero of=/dev/mapper/cmeta bs=4k count=1 oflag=direct
dmsetup create cache --table "0 262144 cache /dev/mapper/cmeta \
/dev/mapper/cdata /dev/mapper/corig 128 2 metadata2 writeback smq \
2 migration_threshold 0"
2. Preload a table in passthrough mode
dmsetup reload cache --table "0 262144 cache /dev/mapper/cmeta \
/dev/mapper/cdata /dev/mapper/corig 128 2 metadata2 passthrough smq 0"
3. Write to the first cache block to make it dirty
fio --filename=/dev/mapper/cache --name=populate --rw=write --bs=4k \
--direct=1 --size=64k
4. Resume the inactive table. Now it's possible to load the dirty block
into passthrough mode.
dmsetup resume cache
Fix by moving the checks to the preresume phase to support table
preloading. Also remove the unused function dm_cache_metadata_all_clean.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
iommu/amd: Fix clone_alias() to use the original device's devid
Currently clone_alias() assumes first argument (pdev) is always the
original device pointer. This function is called by
pci_for_each_dma_alias() which based on topology decides to send
original or alias device details in first argument.
This meant that the source devid used to look up and copy the DTE
may be incorrect, leading to wrong or stale DTE entries being
propagated to alias device.
Fix this by passing the original pdev as the opaque data argument to
both the direct clone_alias() call and pci_for_each_dma_alias(). Inside
clone_alias(), retrieve the original device from data and compute devid
from it.
CVSS Score
8.8
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
ocfs2/dlm: validate qr_numregions in dlm_match_regions()
Patch series "ocfs2/dlm: fix two bugs in dlm_match_regions()".
In dlm_match_regions(), the qr_numregions field from a DLM_QUERY_REGION
network message is used to drive loops over the qr_regions buffer without
sufficient validation. This series fixes two issues:
- Patch 1 adds a bounds check to reject messages where qr_numregions
exceeds O2NM_MAX_REGIONS. The o2net layer only validates message
byte length; it does not constrain field values, so a crafted message
can set qr_numregions up to 255 and trigger out-of-bounds reads past
the 1024-byte qr_regions buffer.
- Patch 2 fixes an off-by-one in the local-vs-remote comparison loop,
which uses '<=' instead of '<', reading one entry past the valid range
even when qr_numregions is within bounds.
This patch (of 2):
The qr_numregions field from a DLM_QUERY_REGION network message is used
directly as loop bounds in dlm_match_regions() without checking against
O2NM_MAX_REGIONS. Since qr_regions is sized for at most O2NM_MAX_REGIONS
(32) entries, a crafted message with qr_numregions > 32 causes
out-of-bounds reads past the qr_regions buffer.
Add a bounds check for qr_numregions before entering the loops.
CVSS Score
9.1
EPSS Score
0.005
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
memory: tegra124-emc: Fix dll_change check
The code checking whether the specified memory timing enables DLL
in the EMRS register was reversed. DLL is enabled if bit A0 is low.
Fix the check.
CVSS Score
9.8
EPSS Score
0.005
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
efi/capsule-loader: fix incorrect sizeof in phys array reallocation
The krealloc() call for cap_info->phys in __efi_capsule_setup_info() uses
sizeof(phys_addr_t *) instead of sizeof(phys_addr_t), which might be
causing an undersized allocation.
The allocation is also inconsistent with the initial array allocation in
efi_capsule_open() that allocates one entry with sizeof(phys_addr_t),
and the efi_capsule_write() function that stores phys_addr_t values (not
pointers) via page_to_phys().
On 64-bit systems where sizeof(phys_addr_t) == sizeof(phys_addr_t *), this
goes unnoticed. On 32-bit systems with PAE where phys_addr_t is 64-bit but
pointers are 32-bit, this allocates half the required space, which might
lead to a heap buffer overflow when storing physical addresses.
This is similar to the bug fixed in commit fccfa646ef36 ("efi/capsule-loader:
fix incorrect allocation size") which fixed the same issue at the initial
allocation site.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
gfs2: add some missing log locking
Function gfs2_logd() calls the log flushing functions gfs2_ail1_start(),
gfs2_ail1_wait(), and gfs2_ail1_empty() without holding sdp->sd_log_flush_lock,
but these functions require exclusion against concurrent transactions.
To fix that, add a non-locking __gfs2_log_flush() function. Then, in
gfs2_logd(), take sdp->sd_log_flush_lock before calling the above mentioned log
flushing functions and __gfs2_log_flush().
CVSS Score
9.8
EPSS Score
0.005
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
bpf, arm64: Fix off-by-one in check_imm signed range check
check_imm(bits, imm) is used in the arm64 BPF JIT to verify that
a branch displacement (in arm64 instruction units) fits into the
signed N-bit immediate field of a B, B.cond or CBZ/CBNZ encoding
before it is handed to the encoder. The macro currently tests for
(imm > 0 && imm >> bits) || (imm < 0 && ~imm >> bits) which admits
values in [-2^N, 2^N) — effectively a signed (N+1)-bit range. A
signed N-bit field only holds [-2^(N-1), 2^(N-1)), so the check
admits one extra bit of range on each side.
In particular, for check_imm19(), values in [2^18, 2^19) slip past
the check but do not fit into the 19-bit signed imm19 field of
B.cond. aarch64_insn_encode_immediate() then masks the raw value
into the 19-bit field, setting bit 18 (the sign bit) and flipping
a forward branch into a backward one. Same class of issue exists
for check_imm26() and the B/BL encoding. Shift by (bits - 1)
instead of bits so the actual signed N-bit range is enforced.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-24