Linux: >> Linux Kernel >> 3.18.31 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
HID: appleir: fix UAF on pending key_up_timer in remove()
appleir_remove() runs hid_hw_stop() before timer_delete_sync().
hid_hw_stop() synchronously unregisters the HID input device via
hid_disconnect() -> hidinput_disconnect() -> input_unregister_device(),
which drops the last reference and frees the underlying input_dev when
no userspace handle holds it open.
key_up_tick() reads appleir->input_dev and calls input_report_key() /
input_sync() on it. The timer is armed from appleir_raw_event() with
a HZ/8 (~125 ms) timeout on every keydown and key-repeat report. If a
key was pressed shortly before the device is disconnected, the timer
can fire after hid_hw_stop() has freed input_dev but before the
teardown drains it.
A simple reorder is not sufficient. Putting the timer drain first
still leaves a window where a USB URB completion (raw_event) running
during hid_hw_stop() can call mod_timer() and re-arm the timer, which
then fires after hidinput_disconnect() has freed input_dev. The same
URB-completion window also lets raw_event() reach key_up(), key_down()
and battery_flat() directly, all of which dereference
appleir->input_dev.
Introduce a 'removing' flag on struct appleir, gated by the existing
spinlock. appleir_remove() sets the flag under the lock and then
shuts down the timer with timer_shutdown_sync(), which both drains any
in-flight callback and permanently disables further mod_timer() calls.
appleir_raw_event() and key_up_tick() bail out early if the flag is
set, so no path can arm or run the timer, or dereference
appleir->input_dev, after remove() has started tearing down.
The keyrepeat and flatbattery branches of appleir_raw_event()
previously called into the input layer without holding the spinlock;
take it now so the flag check is well-defined. This incidentally
closes a pre-existing read-side race on appleir->current_key in the
keyrepeat branch.
This bug is structurally a sibling of commit 4db2af929279 ("HID:
appletb-kbd: fix UAF in inactivity-timer cleanup path") and has been
present since the driver was introduced.
CVSS Score
7.8
EPSS Score
0.002
Published
2026-07-25
In the Linux kernel, the following vulnerability has been resolved:
usb: free iso schedules on failed submit
EHCI and FOTG210 isochronous submits build an ehci_iso_sched before
linking the URB to the endpoint queue, and keep the staged schedule in
urb->hcpriv until iso_stream_schedule() and the link helpers consume it.
If the controller is no longer accessible, or usb_hcd_link_urb_to_ep()
fails, submit jumps to done_not_linked before that handoff happens and
leaks the staged schedule still attached to urb->hcpriv.
Free the staged schedule from done_not_linked when submit fails before
the URB is linked and clear urb->hcpriv after the free.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing
v6.13-rc1. The tool is still under development and is not yet publicly
available. Manual inspection confirms that the bug is still
present in v7.1.1.
An x86_64 allyesconfig build showed no new warnings. As we do not have an
EHCI host controller with a USB isochronous device to test with, no
runtime testing was able to be performed.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-07-25
In the Linux kernel, the following vulnerability has been resolved:
net: usb: kalmia: bound RX frame length in kalmia_rx_fixup()
kalmia_rx_fixup() computes usb_packet_length = skb->len - (2 *
KALMIA_HEADER_LENGTH) as a u16, guarded only by a pre-loop check that
skb->len is at least KALMIA_HEADER_LENGTH, which is 6. A device can
deliver a short bulk-IN frame with skb->len in the 6 to 11 range, or
leave a short trailing remainder on a later loop iteration. Either case
underflows usb_packet_length to about 65530.
That bypasses the usb_packet_length < ether_packet_length truncation path.
The device-supplied ether_packet_length, a le16 up to 65535 read from
header_start[2], then drives a memcmp() and the following skb_trim() and
skb_pull() past the end of the rx buffer. The rx buffer is hard_mtu * 10,
which is 14000 bytes. That is an out of bounds read.
Require both the start and end framing headers to be present before
subtracting them, on every loop iteration.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-25
In the Linux kernel, the following vulnerability has been resolved:
USB: iowarrior: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still use the lock object
after it's unlocked")
CVSS Score
7.8
EPSS Score
0.001
Published
2026-07-25
In the Linux kernel, the following vulnerability has been resolved:
USB: iowarrior: fix use-after-free on disconnect
Submitted write URBs are not stopped on close() and therefore need to be
stopped unconditionally on disconnect() to avoid use-after-free in the
completion handler.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-07-25
In the Linux kernel, the following vulnerability has been resolved:
USB: ldusb: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is
non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still use the lock object
after it's unlocked")
CVSS Score
7.8
EPSS Score
0.001
Published
2026-07-25
In the Linux kernel, the following vulnerability has been resolved:
USB: idmouse: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is
non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still use the lock object
after it's unlocked")
CVSS Score
7.8
EPSS Score
0.001
Published
2026-07-25
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: digi_acceleport: fix write buffer corruption
The digi_write_inb_command() is supposed to wait for the write urb to
become available or return an error, but instead it updates the transfer
buffer and tries to resubmit the urb on timeout.
To make things worse, for commands like break control where no timeout
is used, the driver would corrupt the urb immediately due to a broken
jiffies comparison (on 32-bit machines this takes five minutes of uptime
to trigger due to INITIAL_JIFFIES).
Fix this by adding the missing return on timeout and waiting
indefinitely when no timeout has been specified as intended.
This issue was (sort of) flagged by Sashiko when reviewing an unrelated
change to the driver.
CVSS Score
7.8
EPSS Score
0.002
Published
2026-07-25
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: digi_acceleport: fix hard lockup on disconnect
If submitting the OOB write urb fails persistently (e.g if the device is
being disconnected) the driver would loop indefinitely with interrupts
disabled.
Check for urb submission errors when sending OOB commands to avoid
hanging if, for example, open(), set_termios() or close() races with a
physical disconnect.
This is issue was flagged by Sashiko when reviewing an unrelated change
to the driver.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-25
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: digi_acceleport: fix broken rx after throttle
If the port is closed while throttled, the read urb is never resubmitted
and the port will not receive any further data until the device is
reconnected (or the driver is rebound).
Clear the throttle flags and submit the urb if needed when opening the
port.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-25