Linux: >> Linux Kernel >> 2.6.16 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: bnep: reject short frames before parsing
A BNEP peer can send a short BNEP SDU. bnep_rx_frame() reads the
packet type byte immediately and, for control packets, reads the control
opcode and setup UUID-size byte before proving that those bytes are
present. bnep_rx_control() also dereferences the control opcode without
rejecting an empty control payload.
Use skb_pull_data() for the fixed fields in bnep_rx_frame() so a NULL
return gates each dereference. Split the control handler so the frame
path can pass an opcode that has already been pulled, and keep the
byte-buffer wrapper for extension control payloads.
For BNEP_SETUP_CONN_REQ, name the UUID-size byte before pulling the
setup payload. struct bnep_setup_conn_req carries destination and source
service UUIDs after that byte, each uuid_size bytes, so the parser now
documents that tuple explicitly instead of leaving the pull length as an
opaque multiplication.
Validation reproduced this kernel report:
KASAN slab-out-of-bounds in bnep_rx_frame.isra.0+0x130c/0x1790
The buggy address belongs to the object at ffff88800c0f7908 which belongs
to the cache kmalloc-8 of size 8
The buggy address is located 0 bytes to the right of allocated 1-byte
region [ffff88800c0f7908, ffff88800c0f7909)
Read of size 1
Call trace:
dump_stack_lvl+0xb3/0x140 (?:?)
print_address_description+0x57/0x3a0 (?:?)
bnep_rx_frame+0x130c/0x1790 (net/bluetooth/bnep/core.c:306)
print_report+0xb9/0x2b0 (?:?)
__virt_addr_valid+0x1ba/0x3a0 (?:?)
srso_alias_return_thunk+0x5/0xfbef5 (?:?)
kasan_addr_to_slab+0x21/0x60 (?:?)
kasan_report+0xe0/0x110 (?:?)
process_one_work+0xfce/0x17e0 (kernel/workqueue.c:3200)
worker_thread+0x65c/0xe40 (?:?)
__kthread_parkme+0x184/0x230 (?:?)
kthread+0x35e/0x470 (?:?)
_raw_spin_unlock_irq+0x28/0x50 (?:?)
ret_from_fork+0x586/0x870 (?:?)
__switch_to+0x74f/0xdc0 (?:?)
ret_from_fork_asm+0x1a/0x30 (?:?)
CVSS Score
7.1
EPSS Score
0.003
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: validate skb length in MCC handlers
The RFCOMM MCC handlers cast skb->data to protocol-specific structs
without validating skb->len first. A malicious remote device can send
truncated MCC frames and trigger out-of-bounds reads in these handlers.
Fix this by using skb_pull_data() to validate and access the required
data before dereferencing it.
rfcomm_recv_rpn() requires special handling since ETSI TS 07.10 allows
1-byte RPN requests. Handle this by validating only the DLCI byte first,
and validating the full struct only when len > 1.
CVSS Score
8.1
EPSS Score
0.003
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: hold listener socket in rfcomm_connect_ind()
rfcomm_get_sock_by_channel() scans rfcomm_sk_list under the list lock,
but returns the selected listener after dropping that lock without
taking a reference. rfcomm_connect_ind() then locks the listener,
queues a child socket on it, and may notify it after unlocking it.
The buggy scenario involves two paths, with each column showing the
order within that path:
rfcomm_connect_ind(): listener close:
1. Find parent in 1. close() enters
rfcomm_get_sock_by_channel() rfcomm_sock_release().
2. Drop rfcomm_sk_list.lock 2. rfcomm_sock_shutdown()
without pinning parent. closes the listener.
3. Call lock_sock(parent) and 3. rfcomm_sock_kill()
bt_accept_enqueue(parent, unlinks and puts parent.
sk, true).
4. Read parent flags and may 4. parent can be freed.
call sk_state_change().
If close wins the race, parent can be freed before
rfcomm_connect_ind() reaches lock_sock(), bt_accept_enqueue(), or the
deferred-setup callback.
Take a reference on the listener before leaving rfcomm_sk_list.lock.
After lock_sock() succeeds, recheck that it is still in BT_LISTEN
before queueing a child, cache the deferred-setup bit while the parent
is locked, and drop the reference after the last parent use.
KASAN reported a slab-use-after-free in lock_sock_nested() from
rfcomm_connect_ind(), with the freeing stack going through
rfcomm_sock_kill() and rfcomm_sock_release().
CVSS Score
8.0
EPSS Score
0.002
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
sctp: validate cached peer INIT chunk length in COOKIE_ECHO processing
When a listening SCTP server processes a COOKIE_ECHO chunk, the cached
peer INIT chunk embedded after the cookie is parsed and its parameters
are later walked by sctp_process_init() using sctp_walk_params().
However, the chunk header length of this cached INIT chunk was not
validated against the remaining buffer in the COOKIE_ECHO payload. If
the length field is inflated, the parameter walk can run beyond the
actual received data, leading to out-of-bounds reads and potential
memory corruption during later parameter handling (e.g. STATE_COOKIE
processing and kmemdup() copies).
Add a bounds check in sctp_unpack_cookie() to ensure the cached INIT
chunk length does not exceed the available data in the COOKIE_ECHO
buffer before it is used.
CVSS Score
9.8
EPSS Score
0.004
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
ipv4: restrict IPOPT_SSRR and IPOPT_LSRR options
This patch restricts setting Loose Source and Record Route (LSRR)
and Strict Source and Record Route (SSRR) IP options to users
with CAP_NET_RAW capability.
This prevents unprivileged applications from forcing packets to route
through attacker-controlled nodes to leak TCP ISN and possibly other
protocol information.
While LSRR and SSRR are commonly filtered in many network environments,
they may still be supported and forwarded along some network paths.
RFC 7126 (Recommendations on Filtering of IPv4 Packets Containing
IPv4 Options) recommend to drop these options in 4.3 and 4.4.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
tcp: restrict SO_ATTACH_FILTER to priv users
This patch restricts the use of SO_ATTACH_FILTER (cBPF) on TCP sockets
to users with CAP_NET_ADMIN capability.
This blocks potential side-channel attack where an unprivileged application
attaches a filter to leak TCP sequence/acknowledgment numbers.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
sctp: validate embedded INIT chunk and address list lengths in cookie
sctp_unpack_cookie() only checked that the embedded INIT chunk length
did not exceed the remaining cookie payload, but did not ensure that the
INIT chunk is large enough to contain a complete INIT header.
A malformed COOKIE_ECHO can therefore carry a truncated INIT chunk whose
length field is smaller than sizeof(struct sctp_init_chunk). Later,
sctp_process_init() accesses INIT parameters unconditionally, which may
lead to out-of-bounds reads.
In addition, raw_addr_list_len is not fully validated against the
remaining cookie payload. When cookie authentication is disabled, an
attacker can supply an oversized raw_addr_list_len and cause
sctp_raw_to_bind_addrs() to read beyond the end of the cookie. The
address parser also lacks sufficient bounds checks for parameter headers
and lengths, allowing malformed address parameters to trigger
out-of-bounds reads.
Fix this by:
- requiring the embedded INIT chunk length to be at least sizeof(struct
sctp_init_chunk);
- validating that the INIT chunk and raw address list together fit
within the cookie payload;
- verifying sufficient data exists for each address parameter header and
payload before parsing it.
Note that sctp_verify_init() must be called after sctp_unpack_cookie()
and before sctp_process_init() when cookie authentication is disabled.
This will be addressed in a separate patch.
CVSS Score
9.1
EPSS Score
0.005
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: reject BR/EDR signaling packets over MTUsig
net/bluetooth/l2cap_core.c:l2cap_sig_channel() accepts BR/EDR
signaling packets up to the channel MTU and dispatches each command
without enforcing the signaling MTU (MTUsig). A Bluetooth BR/EDR peer
within radio range can send a fixed-channel CID 0x0001 packet that is
larger than MTUsig and contains many L2CAP_ECHO_REQ commands before
pairing. In a real-radio stock-kernel run, one 681-byte signaling
packet containing 168 zero-length ECHO_REQ commands made the target
transmit 168 ECHO_RSP frames over about 220 ms.
Impact: a Bluetooth BR/EDR peer within radio range, before pairing, can
force 168 ECHO_RSP frames from one 681-byte fixed-channel signaling
packet containing packed ECHO_REQ commands.
Define Linux's BR/EDR signaling MTU as the spec minimum of 48 bytes and
reject any larger signaling packet with one L2CAP_COMMAND_REJECT_RSP
carrying L2CAP_REJ_MTU_EXCEEDED before any command is dispatched.
The Bluetooth Core spec wording for MTUExceeded says the reject
identifier shall match the first request command in the packet, and
that packets containing only responses shall be silently discarded.
Linux intentionally deviates from that prescription: silently
discarding desynchronizes the peer because the remote stack never
learns its responses were dropped, and locating the first request
command requires walking command headers past MTUsig, i.e. processing
bytes from a packet we have already decided is too large to process.
We therefore always emit one reject and use the identifier from the
first command header, a single fixed-offset byte read.
The unrestricted BR/EDR signaling parser and ECHO_REQ response path both
trace to the initial git import; no later introducing commit is
available for a Fixes tag.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: io_ti: fix heap overflow in get_manuf_info()
get_manuf_info() reads le16_to_cpu(rom_desc->Size) bytes from the
device I2C EEPROM into a buffer allocated with kmalloc_obj(), which
is sizeof(struct edge_ti_manuf_descriptor) = 10 bytes.
The Size field comes from the device and is only validated (in
check_i2c_image()) to make sure the descriptor fits within
TI_MAX_I2C_SIZE (16384 bytes), not against the destination buffer size.
A malicious USB device can therefore set Size to any value up to 16377,
causing a heap overflow of up to 16367 bytes when plugged into a host
running this driver.
valid_csum() is called after read_rom() and also iterates
buffer[0..Size-1], compounding the out-of-bounds access.
Fix by rejecting descriptors with unexpected length before calling
read_rom().
[ johan: amend commit message; also check for short descriptors ]
CVSS Score
6.8
EPSS Score
0.003
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
RDMA/srp: bound SRP_RSP sense copy by the received length
srp_process_rsp() copies sense data from rsp->data + resp_data_len,
where resp_data_len is the full 32-bit value supplied by the SRP target
and is never checked against the number of bytes actually received
(wc->byte_len). The copy length is bounded to SCSI_SENSE_BUFFERSIZE, so
at most 96 bytes are copied, but the source offset is not bounded.
A malicious or compromised SRP target on the InfiniBand/RoCE fabric that
the initiator has logged into can return an SRP_RSP with
SRP_RSP_FLAG_SNSVALID set and a large resp_data_len. The receive buffer
is allocated at the target-chosen max_ti_iu_len, so the source of the
sense copy lands past the bytes actually received; with resp_data_len
near 0xFFFFFFFF it is gigabytes past the buffer and the read faults.
Copy the sense data only if it has not been truncated, that is, only if
the response header, the response data, and the sense region fit within
the bytes actually received; otherwise drop the sense and log. The
in-tree iSER and NVMe-RDMA receive paths already bound their parse by
wc->byte_len; this brings ib_srp into line with them.
CVSS Score
9.1
EPSS Score
0.005
Published
2026-06-25