Linux: >> Linux Kernel >> 6.13.6 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
ARM: 9475/1: entry: use byte load for KASAN VMAP stack shadow
Commit 44e9a3bb76e5 ("ARM: 9430/1: entry: Do a dummy read from
VMAP shadow") added a dummy read from the KASAN VMAP stack shadow in
__switch_to(). The read uses ldr, but the KASAN shadow address is
byte-granular and is not guaranteed to be word aligned.
ARMv5 faults unaligned word loads. With CONFIG_KASAN_VMALLOC and
CONFIG_VMAP_STACK enabled, ARM926/VersatilePB crashes in __switch_to()
with an alignment exception before reaching init.
Use ldrb for the dummy shadow access. The code only needs to fault in the
shadow mapping if the stack shadow is missing, so a byte load is sufficient
and matches the granularity of KASAN shadow memory.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
KVM: Don't WARN if memory is dirtied without a vCPU when the VM is dying
When marking a page dirty, complain about not having a running/loaded vCPU
if and only if the VM is still alive, i.e. its refcount is non-zero. This
will allow fixing a memory leak for x86 SEV-ES guests without hitting what
is effectively a false positive on the WARN.
For some SEV-ES VM-Exits, KVM keeps a writable mapping of a guest page
across an exit to userspace, and typically unmaps the page on the next
KVM_RUN. But if userspace never calls KVM_RUN after such an exit, then KVM
needs to unmap the page when the vCPU is destroyed, which in turn triggers
the WARN about not having a running vCPU.
Alternatively, SEV-ES could temporarily load the vCPU to suppress the WARN,
as is done in nested_vmx_free_vcpu() (but for completely unrelated reasons;
suppressing WARN from nested_put_vmcs12_pages() is pure happenstance). But
loading a vCPU during destruction is gross (ideally nVMX code would be
cleaned up), risks complicating the SEV-ES code (KVM would need to ensure
the temporarily load()+put() only runs when the vCPU isn't already loaded),
and is ultimately pointless.
The motivation for the WARN is to guard against KVM dirtying guest memory
without pushing the corresponding GFN to the active vCPU's dirty ring, e.g.
to ensure userspace doesn't miss a dirty page. But for the VM's refcount
to reach zero, there can't be _any_ userspace mappings to the dirty ring,
as mapping the dirty ring requires doing mmap() on the vCPU FD. I.e. if
userspace had a valid mapping for the dirty ring, then the vCPU file and
thus the owning VM would still be alive. And so since userspace can't
possibly reach the dirty ring, whether or not KVM technically "misses" a
push to the dirty ring is irrelevant.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
rust: arm64: set uwtable llvm module flag for CONFIG_UNWIND_TABLES
Due to a rustc bug [1] the -Cforce-unwind-tables=y flag only emits the
uwtable annotation for functions, but not for the module. This means
that compiler-generated functions such as 'asan.module_ctor' do not
receive the uwtable annotation.
When CONFIG_UNWIND_PATCH_PAC_INTO_SCS is enabled, this leads to boot
failures because the dwarf information emitted for the kasan
constructors is wrong, which causes the SCS boot patching code to
patch the constructor in an illegal manner. Specifically, the paciasp
instruction is patched, but the autiasp instruction is not. This
mismatch leads to a crash when the constructor is called during boot.
==================================================================
BUG: KASAN: global-out-of-bounds in do_basic_setup+0x4c/0x90
Read of size 8 at addr ffffffe3cc7eb488 by task swapper/0/1
Specifically the faulting instruction is the (*fn)() to invoke the
constructor in do_ctors() of the init/main.c file.
Once the fix lands in rustc, this flag can be made conditional on the
rustc version. Note that passing the flag on a rustc with the fix
present has no effect.
[ The fix [1] has landed for Rust 1.98.0 (expected release on
2026-08-20).
Thus add a version check as discussed.
- Miguel ]
[ Adjusted link and comment. - Miguel ]
CVSS Score
7.1
EPSS Score
0.001
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
drm/virtio: Fix driver removal with disabled KMS
DRM atomic and modesetting aren't initialized if virtio-gpu driver built
with disabled KMS, leading to access of uninitialized data on driver
removal/unbinding and crashing kernel. Fix it by skipping shutting down
atomic core with unavailable KMS.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
slimbus: qcom-ngd-ctrl: Register callbacks after creating the ngd
When the remoteproc starts in parallel with the NGD driver being probed,
or the remoteproc is already up when the PDR lookup is being registered,
or in the theoretical event that we get an interrupt from the hardware,
these callbacks will operate on uninitialized data. This result in
issues to boot the affected boards.
One such example can be seen in the following fault, where
qcom_slim_ngd_ssr_pdr_notify() schedules work on the NULL ngd_up_work.
[ 21.858578] ------------[ cut here ]------------
[ 21.858745] WARNING: kernel/workqueue.c:2338 at __queue_work+0x5e0/0x790, CPU#2: kworker/2:2/116
...
[ 21.859251] Call trace:
[ 21.859255] __queue_work+0x5e0/0x790 (P)
[ 21.859265] queue_work_on+0x6c/0xf0
[ 21.859273] qcom_slim_ngd_ssr_pdr_notify+0x110/0x150 [slim_qcom_ngd_ctrl]
[ 21.859304] qcom_slim_ngd_ssr_notify+0x24/0x40 [slim_qcom_ngd_ctrl]
[ 21.859318] notifier_call_chain+0xa4/0x230
[ 21.859329] srcu_notifier_call_chain+0x64/0xb8
[ 21.859338] ssr_notify_start+0x40/0x78 [qcom_common]
[ 21.859355] rproc_start+0x130/0x230
[ 21.859367] rproc_boot+0x3d4/0x518
...
Move the enablement of interrupts, and the registration of SSR and PDR
until after the NGD device has been registered.
This could be further refined by moving initialization to the control
driver probe and by removing the platform driver model from the picture.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
nvmem: layouts: onie-tlv: fix hang on unknown types
The EEPROM on my board has a vendor specific entry of type 0x41. When
stumbling upon that, this driver hangs in an endless loop.
Fix it by keep incrementing the offset on unknown entries, so the loop
will eventually stop.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
net: bonding: fix NULL pointer dereference in bond_do_ioctl()
In bond_do_ioctl(), slave_dev is obtained via __dev_get_by_name() which
can return NULL if the requested interface name does not exist. However,
the subsequent slave_dbg() call is placed before the NULL check:
slave_dev = __dev_get_by_name(net, ifr->ifr_slave);
slave_dbg(bond_dev, slave_dev, "slave_dev=%p:\n", slave_dev); //here
if (!slave_dev)
return -ENODEV;
The slave_dbg() macro expands to netdev_dbg(bond_dev, "(slave %s): " fmt,
(slave_dev)->name, ...) which unconditionally dereferences slave_dev->name
before the NULL check is performed. This results in a NULL pointer
dereference kernel oops when a user calls bonding ioctl (e.g.
SIOCBONDENSLAVE, SIOCBONDRELEASE, etc.) with a non-existent slave
interface name.
This is reachable from userspace via the bonding ioctl interface with
CAP_NET_ADMIN capability, making it a potential local denial-of-service
vector.
Fix by moving the slave_dbg() call after the NULL check.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
i2c: qcom-cci: Fix NULL pointer dereference in cci_remove()
On all modern platforms Qualcomm CCI controller provides two I2C masters,
and on particular boards only one I2C master may be initialized, and in
such cases the device unbinding or driver removal causes a NULL pointer
dereference, because cci_halt() is called for all two I2C masters, but
a completion is initialized only for the single enabled master:
% rmmod i2c-qcom-cci
Unable to handle kernel NULL pointer dereference at virtual address 0000000000000000
<snip>
Call trace:
__wait_for_common+0x194/0x1a8 (P)
wait_for_completion_timeout+0x20/0x2c
cci_remove+0xc4/0x138 [i2c_qcom_cci]
platform_remove+0x20/0x30
device_remove+0x4c/0x80
device_release_driver_internal+0x1c8/0x224
driver_detach+0x50/0x98
bus_remove_driver+0x6c/0xbc
driver_unregister+0x30/0x60
platform_driver_unregister+0x14/0x20
qcom_cci_driver_exit+0x18/0x1008 [i2c_qcom_cci]
....
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
debugobjects: Do not fill_pool() if pi_blocked_on
On RT enabled kernels, fill_pool() ends up calling rtlock_lock(), which
asserts if current::pi_blocked_on is set, because a task can obviously only
block on one lock as otherwise the priority inheritenace chain gets
corrupted.
Prevent this by expanding the conditional to take current::pi_blocked_on
into account.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
sched_ext: Don't warn on NULL cgrp_moving_from in scx_cgroup_move_task()
A WARN fires when systemd's user manager writes "+cpu +memory +pids" to
its own subtree_control while a sched_ext scheduler is loaded:
WARNING: at kernel/sched/ext.c:3227 scx_cgroup_move_task+0xa8/0xb0
scx_cgroup_move_task+0xa8/0xb0
sched_move_task+0x134/0x290
cpu_cgroup_attach+0x39/0x70
cgroup_migrate_execute+0x37d/0x450
cgroup_update_dfl_csses+0x1e3/0x270
cgroup_subtree_control_write+0x3e7/0x440
scx_cgroup_can_attach() arms cgrp_moving_from only when a task's cpu
cgroup changes. It can still be NULL when scx_cgroup_move_task() runs,
through this sequence:
Step Result
--------------------------------- ----------------------------------
1. cpu enabled on cgroup G cpu css = A
2. cpu toggled off then on for G A killed, B created (same cgroup)
3. an exiting task keeps A alive migration skips it, A now stale
4. +memory migrates G stale A vs current B pulls cpu in
5. cpu attach runs for all tasks hits a live, cpu-unchanged task
6. scx_cgroup_move_task() on it cgrp_moving_from NULL -> WARN
The mismatch is that scx_cgroup_can_attach() keys on cgroup identity
while migration drives the move on css identity, so a NULL cgrp_moving_from
here is a legitimate css-only migration, not a missing prep.
The call is already gated on cgrp_moving_from, so just drop the warning.
ops.cgroup_prep_move() and ops.cgroup_move() stay paired.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-01