In the Linux kernel, the following vulnerability has been resolved:
iommufd: Move vevent memory allocation outside spinlock
The veventq memory allocation happens inside the spinlock. Given its depth
is decided by the user space, this leaves a vulnerability, where userspace
can allocate large queues to exhaust atomic memory reserves.
Move the allocation outside the spinlock and use GFP_NOWAIT, which can fail
fast under memory pressure without dipping into the GFP_ATOMIC reserves or
direct-reclaiming from the threaded IRQ handler. On allocation failure,
queue the lost_events_header (so userspace learns of the drop) and return
-ENOMEM so the caller learns of the kernel-side memory pressure.
This is intentionally distinct from the queue-overflow path, which also
queues the lost_events_header but returns 0: a full queue is an expected
userspace-pacing condition rather than a kernel error.
A subsequent change will cap the upper bound of the veventq_depth.
In the Linux kernel, the following vulnerability has been resolved:
Input: synaptics-rmi4 - bound the F30 keymap to the GPIO/LED count
rmi_f30_map_gpios() allocates gpioled_key_map with
min(gpioled_count, TRACKSTICK_RANGE_END) == at most 6 entries, but
rmi_f30_attention() iterates the full f30->gpioled_count (device query
register, range 0..31) and dereferences gpioled_key_map[i], and
input->keycodemax is set to the full gpioled_count while input->keycode
points at the 6-entry allocation.
A device that reports gpioled_count > 6 with GPIO support enabled
therefore causes an out-of-bounds read on the attention interrupt and
out-of-bounds read/write through the EVIOCGKEYCODE/EVIOCSKEYCODE ioctls,
which bound the index only against keycodemax. This is the same defect
as the F3A handler, which was copied from F30.
Size the keymap for the full gpioled_count; the mapping loop still
assigns only the first min(gpioled_count, TRACKSTICK_RANGE_END) entries.
In the Linux kernel, the following vulnerability has been resolved:
Input: synaptics-rmi4 - bound the F3A keymap to the GPIO count
rmi_f3a_initialize() takes the GPIO count from the device query register
(f3a->gpio_count = buf & RMI_F3A_GPIO_COUNT, range 0..127).
rmi_f3a_map_gpios() then allocates gpio_key_map with
min(gpio_count, TRACKSTICK_RANGE_END) == at most 6 entries, but
rmi_f3a_attention() iterates the full gpio_count and dereferences
gpio_key_map[i], and input->keycodemax is set to the full gpio_count
while input->keycode points at the 6-entry allocation.
A device that reports gpio_count > 6 therefore causes an out-of-bounds
read of gpio_key_map[] on every attention interrupt, and out-of-bounds
accesses through the input core's default keymap ioctls: EVIOCGKEYCODE
reads past the buffer (leaking adjacent slab memory to user space) and
EVIOCSKEYCODE writes a caller-controlled value past it, for any process
able to open the evdev node, since input_default_getkeycode() and
input_default_setkeycode() only bound the index against keycodemax.
Size the keymap for the full gpio_count. The mapping loop is unchanged:
it still assigns only the first min(gpio_count, TRACKSTICK_RANGE_END)
entries; the remaining slots stay KEY_RESERVED (devm_kcalloc zero-fills)
and are skipped when reporting.
In the Linux kernel, the following vulnerability has been resolved:
i2c: imx-lpi2c: mark I2C adapter when hardware is powered down
On some i.MX platforms, certain I2C client drivers keep a periodic
workqueue which continues to trigger I2C transfers.
During system suspend/resume, there exists a time window between:
- suspend_noirq and the system entering suspend
- the system starting to resume and resume_noirq
In this window, the I2C controller resources such as clock and pinctrl
may already be disabled or not yet restored.
If a workqueue triggers an I2C transfer in this period, the driver
attempts to access I2C registers while the hardware resources are
unavailable, which may lead to system hang.
Mark the I2C adapter as suspended during noirq suspend and block new
transfers until resume, ensuring that I2C transfers are only issued
when hardware resources are available.
In the Linux kernel, the following vulnerability has been resolved:
i2c: core: fix adapter deregistration race
Adapters can be looked up by their id using i2c_get_adapter() which
takes a reference to the embedded struct device.
Remove the adapter from the IDR before tearing it down during
deregistration (and on registration failure) to make sure its resources
are not accessed after having been freed (e.g. the device name).
In the Linux kernel, the following vulnerability has been resolved:
fpga: dfl-afu: validate DMA mapping length in afu_dma_map_region()
afu_ioctl_dma_map() accepts a 64-bit length from userspace via
DFL_FPGA_PORT_DMA_MAP ioctl without an upper bound check. The value
is passed to afu_dma_pin_pages() where npages is derived as
length >> PAGE_SHIFT and passed to pin_user_pages_fast() which takes
int nr_pages, causing implicit truncation if length is very large.
Validate map.length at the ioctl entry point before calling
afu_dma_map_region(), rejecting values whose page count exceeds
INT_MAX.
In the Linux kernel, the following vulnerability has been resolved:
svcrdma: wake sq waiters when the transport closes
Threads parked in svc_rdma_sq_wait() on sc_sq_ticket_wait or
sc_send_wait can hang indefinitely in TASK_UNINTERRUPTIBLE state
across transport teardown, pinning svc_xprt references and
blocking svc_rdma_free().
The close path sets XPT_CLOSE before invoking xpo_detach and both
wait_event predicates include an XPT_CLOSE term, but the
predicates are re-evaluated only on wakeup. sc_sq_ticket_wait has
no completion-driven wake path; it is advanced solely by the
chained ticket handoff inside svc_rdma_sq_wait() itself. Without
an explicit wake at close, parked threads never observe
XPT_CLOSE, hold their svc_xprt_get reference forever, and
svc_rdma_free() blocks on xpt_ref dropping to zero.
Two close entry points reach this transport. Local teardown runs
svc_rdma_detach() from svc_handle_xprt() -> svc_delete_xprt() ->
xpo_detach() on a worker thread. A remote disconnect arrives at
svc_rdma_cma_handler(), which calls svc_xprt_deferred_close():
that sets XPT_CLOSE and enqueues the transport but does not
access either RDMA waitqueue, so a worker already parked in
svc_rdma_sq_wait() never re-evaluates its predicate. With every
worker parked on this transport, no thread is available to run
the local teardown either, and the wake site there is
unreachable.
Introduce svc_rdma_xprt_deferred_close(), a thin svcrdma wrapper
that calls svc_xprt_deferred_close() and then wakes both
sc_sq_ticket_wait and sc_send_wait. Convert the svcrdma producers
that called svc_xprt_deferred_close() directly:
svc_rdma_cma_handler(), qp_event_handler(),
svc_rdma_post_send_err(), svc_rdma_wc_send(), the sendto drop
path, the rw completion error paths, and the recvfrom flush and
read-list error paths.
Wake both waitqueues from svc_rdma_detach() as well. The
synchronous svc_xprt_close() path (backchannel ENOTCONN, device
removal via svc_rdma_xprt_done) reaches detach without flowing
through svc_xprt_deferred_close() and therefore does not invoke
the new helper.
[ cel: add svc_rdma_xprt_deferred_close() to complete the fix ]
In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: Don't leak PFN when kvm_translate_vncr() races MMU notifier
In the case that kvm_translate_vncr() races with an MMU notifier the
early return does not release a reference on the faulted in PFN. Add
the necessary call to kvm_release_faultin_page() for the unused PFN.
In the Linux kernel, the following vulnerability has been resolved:
KVM: guest_memfd: Treat memslot binding offset+size as unsigned values
When binding a memslot to a guest_memfd file, treat the offset and size as
unsigned values to fix a bug where the sum of the two can result in a false
negative when checking for overflow against the size of the file. Passing
unsigned values also avoids relying on somewhat obscure checks in other
flows for safety, and tracks the offset and size as they are intended to be
tracked, as unsigned values.
On 64-bit kernels, the number of pages a memslot contains and thus the size
(and offset) of its guest_memfd binding are unsigned 64-bit values. Taking
the offset+size as an loff_t instead of a uoff_t inadvertently converts
the unsigned value to a signed value if the offset and/or size is massive.
Locally storing the offset and size as signed values is benign in and of
itself (though even that is *extremely* difficult to discern), but
operating on their sum is not.
For the offset, KVM explicitly checks against a negative value, which might
seem like a bug as KVM could incorrectly reject a legitimate binding, but
that's not actually the case as KVM_CREATE_GUEST_MEMFD takes a signed value
for its size, i.e. a would-be-negative offset is also greater than the
maximum possible size of any guest_memfd file.
Regarding the size, while KVM lacks an explicit check for a negative value,
i.e. seemingly has a flawed overflow check, KVM restricts the number of
pages in a single memslot to the largest positive signed 32-bit value:
if (id < KVM_USER_MEM_SLOTS &&
(mem->memory_size >> PAGE_SHIFT) > KVM_MEM_MAX_NR_PAGES)
return -EINVAL;
and so that maximum "size" will ever be is 0x7fffffff000.
The sum of the two is, however, problematic. While the size is restricted
by KVM's memslot logic, the offset is not, i.e. the offset is completely
unchecked until the "offset + size > i_size_read(inode)" check. If the
offset is the (nearly) largest possible _positive_ value, then adding size
to the offset can result in a signed, negative 64-bit value. When compared
against the size of the file (guaranteed to be positive), the negative sum
is always smaller, and KVM incorrectly allows the absurd offset.
Opportunistically add missing includes in kvm_mm.h (instead of relying on
its parents).
In the Linux kernel, the following vulnerability has been resolved:
RDMA/siw: bound Read Response placement to the RREAD length
In drivers/infiniband/sw/siw/siw_qp_rx.c, siw_proc_rresp() places each
inbound Read Response DDP segment at sge->laddr + wqe->processed and then
accumulates wqe->processed, but it never checks the running total against
the sink buffer length on continuation segments. siw_check_sge() resolves
and validates the sink memory only on the first fragment (the if (!*mem)
branch), and siw_rresp_check_ntoh() compares the cumulative length against
wqe->bytes only on the final segment (the !frx->more_ddp_segs guard).
A connected siw peer that answers an outstanding RREAD with Read Response
segments that keep the DDP Last flag clear, carrying more total payload
than the RREAD requested, drives wqe->processed past the validated sink
buffer; the next siw_rx_data() call writes out of bounds at
sge->laddr + wqe->processed. siw runs iWARP over ordinary routable TCP,
so the peer is the remote end of an established RDMA connection and needs
no local privilege.
Bound every segment before placement, exactly as siw_proc_send() and
siw_proc_write() already do for their tagged and untagged paths, and
terminate the connection with a base-or-bounds DDP error when the
Read Response would overrun the sink buffer.
This is the second receive-path length fix for this file. A separate
change rejects an MPA FPDU length that underflows the per-fragment
remainder in the header decode; that guard does not cover this case,
because here each individual segment length is self-consistent and only
the accumulated placement offset overruns the buffer.