In the Linux kernel, the following vulnerability has been resolved:
udp: clear skb->dev before running a sockmap verdict
On the UDP receive path skb->dev is repurposed as dev_scratch (the
truesize/state cache set by udp_set_dev_scratch()), through the
union { struct net_device *dev; unsigned long dev_scratch; } in sk_buff.
When a UDP socket is in a sockmap, sk_data_ready is
sk_psock_verdict_data_ready(), which calls udp_read_skb() -> recv_actor()
(sk_psock_verdict_recv) to run the attached SK_SKB verdict program in softirq.
If that program calls a socket-lookup helper (bpf_sk_lookup_tcp/udp,
bpf_skc_lookup_tcp), bpf_skc_lookup() does:
if (skb->dev)
caller_net = dev_net(skb->dev);
skb->dev still holds the dev_scratch value (a non-NULL integer), so dev_net()
dereferences it as a struct net_device * and the kernel takes a general
protection fault on a non-canonical address in softirq:
Oops: general protection fault, probably for non-canonical address 0x1010000800004a0
CPU: 1 UID: 0 PID: 1406 Comm: syz.2.19 Not tainted 7.1.0-rc6 #1 PREEMPT(full)
RIP: 0010:bpf_skc_lookup net/core/filter.c:7033 [inline]
RIP: 0010:bpf_sk_lookup+0x45/0x160 net/core/filter.c:7047
Call Trace:
<IRQ>
bpf_prog_4675cb904b7071f8+0x12e/0x14e
bpf_prog_run_pin_on_cpu+0xc6/0x1f0
sk_psock_verdict_recv+0x1ba/0x350
udp_read_skb+0x31a/0x370
sk_psock_verdict_data_ready+0x2e3/0x600
__udp_enqueue_schedule_skb+0x4c8/0x650
udpv6_queue_rcv_one_skb+0x3ec/0x740
udp6_unicast_rcv_skb+0x11d/0x140
ip6_protocol_deliver_rcu+0x61e/0x950
ip6_input_finish+0xa9/0x150
NF_HOOK+0x286/0x2f0
ip6_input+0x117/0x220
NF_HOOK+0x286/0x2f0
__netif_receive_skb+0x85/0x200
process_backlog+0x374/0x9a0
__napi_poll+0x4f/0x1c0
net_rx_action+0x3b0/0x770
handle_softirqs+0x15a/0x460
do_softirq+0x57/0x80
</IRQ>
The rmem charge that dev_scratch accounted for is released by skb_recv_udp() on
dequeue, just above, so the scratch is dead by the time recv_actor() runs. Clear
skb->dev so bpf_skc_lookup() falls back to sock_net(skb->sk), which
skb_set_owner_sk_safe() set just above.
In the Linux kernel, the following vulnerability has been resolved:
zram: fix use-after-free in zram_bvec_write_partial()
zram_read_page() picks the sync or async backing device read path based on
whether the parent bio is NULL. zram_bvec_write_partial() passes its
parent bio down, so for ZRAM_WB slots the read is dispatched
asynchronously and zram_read_page() returns 0 while the bio is still in
flight. The caller then runs memcpy_from_bvec(), zram_write_page() and
__free_page() on the buffer, leaving the async read to write into a freed
page.
zram_bvec_read_partial() was switched to NULL in commit 4e3c87b9421d
("zram: fix synchronous reads") for the same reason; the write_partial
counterpart was missed.
In the Linux kernel, the following vulnerability has been resolved:
fuse: reject fuse_notify() pagecache ops on directories
The operations FUSE_NOTIFY_STORE and FUSE_NOTIFY_RETRIEVE allow the
FUSE daemon to actively write/read pagecache contents.
For directories with FOPEN_CACHE_DIR, the pagecache is used as
kernel-internal cache storage, and userspace is not supposed to have
direct access to this cache - in particular, fuse_parse_cache() will hit
WARN_ON() if the cache contains bogus data.
Reject FUSE_NOTIFY_STORE and FUSE_NOTIFY_RETRIEVE on anything other than
regular files with -EINVAL.
In the Linux kernel, the following vulnerability has been resolved:
inet: frags: fix use-after-free caused by the fqdir_pre_exit() flush
On netns teardown, fqdir_pre_exit() walks the fqdir rhashtable and
flushes every fragment queue that is not yet complete using
inet_frag_queue_flush(). That helper frees all the skbs queued on the
fragment queue but does not set INET_FRAG_COMPLETE, and leaves
q->fragments_tail and q->last_run_head pointing at the freed skbs.
The queue itself stays in the rhashtable.
fqdir_pre_exit() first lowers high_thresh to 0 to stop new queue lookups,
but it cannot stop a fragment that already obtained the queue through
inet_frag_find() earlier and stalled just before taking the queue lock.
Once that fragment resumes after the flush and takes the queue lock,
it passes the INET_FRAG_COMPLETE check and then dereferences the freed
fragments_tail. inet_frag_queue_insert() reads FRAG_CB() and ->len of
that pointer and, on the append path, writes ->next_frag, causing a
slab use-after-free. IPv6, nf_conntrack_reasm6 and 6lowpan reassembly
share the same flush path and are affected as well.
Reset rb_fragments, fragments_tail and last_run_head in
inet_frag_queue_flush() so a flushed queue no longer points at the
freed skbs. A fragment that resumes after the flush and takes the
queue lock then finds an empty queue and starts a new run instead of
dereferencing the freed fragments_tail. ip_frag_reinit() already
performed this reset after its own flush, so drop the now duplicate
code there.
In the Linux kernel, the following vulnerability has been resolved:
IB/isert: Reject login PDUs shorter than ISER_HEADERS_LEN
In drivers/infiniband/ulp/isert/ib_isert.c, isert_login_recv_done()
computes the login request payload length as wc->byte_len minus
ISER_HEADERS_LEN with no lower bound, and login_req_len is a signed int.
A remote iSER initiator can post a login Send work request carrying
fewer than ISER_HEADERS_LEN (76) bytes, so the subtraction underflows
and login_req_len becomes negative.
isert_rx_login_req() then reads that negative length back into a signed
int, takes size = min(rx_buflen, MAX_KEY_VALUE_PAIRS), and because the
min() is signed it keeps the negative value; the value is then passed as
the memcpy() length and sign-extended to a multi-gigabyte size_t. The
copy into the 8192-byte login->req_buf runs far out of bounds and
faults, crashing the target node. The login phase precedes iSCSI
authentication, so no credentials are required to reach this path.
Reject any login PDU shorter than ISER_HEADERS_LEN before the
subtraction, mirroring the existing early return on a failed work
completion, so login_req_len can never go negative. The upper bound was
already safe: a posted login buffer cannot deliver more than
ISER_RX_PAYLOAD_SIZE, so the difference stays at or below
MAX_KEY_VALUE_PAIRS and the existing min() clamps it; only the missing
lower bound needs to be added.
In the Linux kernel, the following vulnerability has been resolved:
fuse: limit FUSE_NOTIFY_RETRIEVE to uptodate folios
FUSE_NOTIFY_RETRIEVE must be limited to uptodate folios; !uptodate folios
can contain uninitialized data.
Since FUSE_NOTIFY_RETRIEVE is intended to only return data that is already
in the page cache and not wait for data from the FUSE daemon, treat
!uptodate folios as if they weren't present.
This only has security impact on systems that don't enable automatic
zero-initialization of all page allocations via
CONFIG_INIT_ON_ALLOC_DEFAULT_ON or init_on_alloc=1.
In the Linux kernel, the following vulnerability has been resolved:
net: phonet: free phonet_device after RCU grace period
phonet_device_destroy() removes a phonet_device from the per-net device
list with list_del_rcu(), but frees it immediately. RCU readers walking
the same list can still hold a pointer to the object after it has been
removed, leading to a slab-use-after-free.
Use kfree_rcu(), matching the lifetime rule already used by
phonet_address_del() for the same object type.
In the Linux kernel, the following vulnerability has been resolved:
misc: fastrpc: Fix NULL pointer dereference in rpmsg callback
A NULL pointer dereference was observed on Hawi at boot when the DSP
sends a glink message before fastrpc_rpmsg_probe() has completed
initialization:
Unable to handle kernel NULL pointer dereference at virtual address 0000000000000178
pc : _raw_spin_lock_irqsave+0x34/0x8c
lr : fastrpc_rpmsg_callback+0x3c/0xcc [fastrpc]
...
Call trace:
_raw_spin_lock_irqsave+0x34/0x8c (P)
fastrpc_rpmsg_callback+0x3c/0xcc [fastrpc]
qcom_glink_native_rx+0x538/0x6a4
qcom_glink_smem_intr+0x14/0x24 [qcom_glink_smem]
The faulting address 0x178 corresponds to the lock variable inside
struct fastrpc_channel_ctx, confirming that cctx is NULL when
fastrpc_rpmsg_callback() attempts to take the spinlock.
There are two issues here. First, dev_set_drvdata() is called before
spin_lock_init() and idr_init(), leaving a window where the callback
can retrieve a valid cctx pointer but operate on an uninitialized
spinlock. Second, the rpmsg channel becomes live as soon as the driver
is bound, so fastrpc_rpmsg_callback() can fire before dev_set_drvdata()
is called at all, resulting in dev_get_drvdata() returning NULL.
Fix both issues by moving all cctx initialization ahead of
dev_set_drvdata() so the structure is fully initialized before it
becomes visible to the callback, and add a NULL check in
fastrpc_rpmsg_callback() as a guard against any remaining window.
In the Linux kernel, the following vulnerability has been resolved:
misc: fastrpc: fix DMA address corruption due to find_vma misuse
fastrpc_get_args() uses find_vma() to look up the VMA for a user-provided
pointer and compute a DMA address offset. When the address falls in a gap
before the returned VMA, (ptr & PAGE_MASK) - vma->vm_start underflows,
corrupting the DMA address sent to the DSP.
Replace find_vma() with vma_lookup(), which returns NULL when the address
is not contained within any VMA.
In the Linux kernel, the following vulnerability has been resolved:
misc: fastrpc: fix use-after-free race in fastrpc_map_create
fastrpc_map_lookup returns a raw pointer after releasing fl->lock. The
caller fastrpc_map_create then calls fastrpc_map_get (kref_get_unless_zero)
on this unprotected pointer. A concurrent MEM_UNMAP can free the map
between the lock release and the kref operation, resulting in a
use-after-free on the freed slab object.
Restore the take_ref parameter to fastrpc_map_lookup so the reference
is acquired atomically under fl->lock before the pointer is exposed to
the caller.