In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/vce: Prevent partial address patches
In the case that only one of lo/hi is valid, the patching could result
in a bad address written to in FW.
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Add upper bound check for num_of_nodes
drm/amdkfd: Add upper bound check for num_of_nodes
in kfd_ioctl_get_process_apertures_new.
(cherry picked from commit 98ff46a5ea090c14d2cdb4f5b993b05d74f3949f)
In the Linux kernel, the following vulnerability has been resolved:
drm/msm: always recover the gpu
Previously, in case there was no more work to do, recover worker
wouldn't trigger recovery and would instead rely on the gpu going to
sleep and then resuming when more work is submitted.
Recover_worker will first increment the fence of the hung ring so, if
there's only one job submitted to a ring and that causes an hang, it
will early out.
There's no guarantee that the gpu will suspend and resume before more
work is submitted and if the gpu is in a hung state it will stay in that
state and probably trigger a timeout again.
Just stop checking and always recover the gpu.
Patchwork: https://patchwork.freedesktop.org/patch/704066/
In the Linux kernel, the following vulnerability has been resolved:
udf: reject descriptors with oversized CRC length
udf_read_tagged() skips CRC verification when descCRCLength +
sizeof(struct tag) exceeds the block size. A crafted UDF image can
set descCRCLength to an oversized value to bypass CRC validation
entirely; the descriptor is then accepted based solely on the 8-bit
tag checksum, which is trivially recomputable.
Reject such descriptors instead of silently accepting them. A
legitimate single-block descriptor should never have a CRC length that
exceeds the block.
In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix fsck inconsistency caused by incorrect nat_entry flag usage
f2fs_need_dentry_mark() reads nat_entry flags without mutual exclusion
with the checkpoint path, which can result in an incorrect inode block
marking state. The scenario is as follows:
create & write & fsync 'file A' write checkpoint
- f2fs_do_sync_file // inline inode
- f2fs_write_inode // inode folio is dirty
- f2fs_write_checkpoint
- f2fs_flush_merged_writes
- f2fs_sync_node_pages
- f2fs_fsync_node_pages // no dirty node
- f2fs_need_inode_block_update // return true
- f2fs_fsync_node_pages // inode dirtied
- f2fs_need_dentry_mark //return true
- f2fs_flush_nat_entries
- f2fs_write_checkpoint end
- __write_node_folio // inode with DENT_BIT_SHIFT set
SPO, "fsck --dry-run" find inode has already checkpointed but still
with DENT_BIT_SHIFT set
The state observed by f2fs_need_dentry_mark() can differ from the state
observed in __write_node_folio() after acquiring sbi->node_write. The
root cause is that the semantics of IS_CHECKPOINTED and
HAS_FSYNCED_INODE are only guaranteed after the checkpoint write has
fully completed.
This patch moves set_dentry_mark() into __write_node_folio() and
protects it with the sbi->node_write lock.
In the Linux kernel, the following vulnerability has been resolved:
ipv4: account for fraggap on the paged allocation path
In __ip_append_data(), when the paged-allocation branch is taken,
alloclen and pagedlen are computed as
alloclen = fragheaderlen + transhdrlen;
pagedlen = datalen - transhdrlen;
datalen already includes fraggap, but the fraggap bytes carried over
from the previous skb are copied into the new skb's linear area at
offset transhdrlen by the subsequent skb_copy_and_csum_bits(). The
linear area is therefore undersized by fraggap bytes while pagedlen is
overstated by the same amount.
The non-paged branch sets alloclen to fraglen, which already accounts
for fraggap because datalen does. Bring the paged branch in line by
adding fraggap to alloclen and subtracting it from pagedlen.
After this adjustment, copy no longer collapses to -fraggap on the
paged path, so remove the stale comment describing that old arithmetic.
In the Linux kernel, the following vulnerability has been resolved:
ipv6: account for fraggap on the paged allocation path
In __ip6_append_data(), when the paged-allocation branch is taken
(MSG_MORE / NETIF_F_SG / large fraglen), alloclen and pagedlen are
computed as
alloclen = fragheaderlen + transhdrlen;
pagedlen = datalen - transhdrlen;
datalen already includes fraggap (datalen = length + fraggap). When
fraggap is non-zero, this is not the first skb and transhdrlen is zero.
The fraggap bytes carried over from the previous skb are copied just past
the fragment headers in the new skb's linear area. The linear area is
therefore undersized by fraggap bytes while pagedlen is overstated by the
same amount, and the copy writes past skb->end into the trailing
skb_shared_info.
An unprivileged user can trigger this via a UDPv6 socket using
MSG_MORE together with MSG_SPLICE_PAGES.
The bad accounting was introduced by commit 773ba4fe9104 ("ipv6:
avoid partial copy for zc"). Before commit ce650a166335 ("udp6: Fix
__ip6_append_data()'s handling of MSG_SPLICE_PAGES"), the negative
copy value caused -EINVAL to be returned. That later commit allowed
MSG_SPLICE_PAGES to proceed in this case, making the corruption
triggerable.
The non-paged branch sets alloclen to fraglen, which already accounts
for fraggap because datalen does. Bring the paged branch in line by
adding fraggap to alloclen and subtracting it from pagedlen.
After this adjustment, copy no longer collapses to -fraggap on the
paged path, so remove the stale comment describing that old arithmetic.
Since a negative copy is no longer expected for a valid MSG_SPLICE_PAGES
case, remove the MSG_SPLICE_PAGES exception from the negative copy check.
In the Linux kernel, the following vulnerability has been resolved:
KVM: x86: Fix shadow paging use-after-free due to unexpected role
Commit 0cb2af2ea66ad ("KVM: x86: Fix shadow paging use-after-free due
to unexpected GFN") fixed a shadow paging mismatch between stored and
computed GFNs; the bug could be triggered by changing a PDE mapping from
outside the guest, and then deleting a memslot. The rmap_remove()
call would miss entries created after the PDE change because the GFN
of the leaf SPTE does not match the GFN of the struct kvm_mmu_page.
A similar hole however remains if the modified PDE points to a non-leaf
page. In this case the gfn can be made to match, but the role does not
match: the original large 2MB page creates a kvm_mmu_page with direct=1,
while the new 4KB needs a kvm_mmu_page with direct=0. However,
kvm_mmu_get_child_sp() does not compare the role, and therefore reuses
the page.
The next step is installing a leaf (4KB) SPTE on the new path which
records an rmap entry under the gfn resolved by the walk. But when
that child is zapped its parent kvm_mmu_page has direct=1 and
kvm_mmu_page_get_gfn() computes the gfn for the 4KB page as
sp->gfn + index instead of using sp->shadowed_translation[] (or sp->gfns[]
in older kernels). It therefore fails to remove the recorded entry.
When the memslot is dropped the shadow page is freed but the rmap
entry survives, as in the scenario that was already fixed. Code that
later walks that gfn (dirty logging, MMU notifier invalidation, and
so on) dereferences an sptep that lies in the freed page, causing the
use-after-free.
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: fix UAF in l2cap_sock_cleanup_listen() vs l2cap_conn_del()
bt_accept_dequeue() unlinks a not-yet-accepted child from the parent
accept queue and release_sock()s it before returning, so the returned
sk has no caller reference and is unlocked.
l2cap_sock_cleanup_listen() walks these children on listening-socket
close. A concurrent HCI disconnect drives hci_rx_work ->
l2cap_conn_del() which runs l2cap_chan_del() + l2cap_sock_kill() and
frees the child sk and its l2cap_chan; cleanup_listen() then uses both:
BUG: KASAN: slab-use-after-free in l2cap_sock_kill
l2cap_sock_kill / l2cap_sock_cleanup_listen / __x64_sys_close
Freed by: l2cap_conn_del -> l2cap_sock_close_cb -> l2cap_sock_kill
This is distinct from the two fixes already in this area: commit
e83f5e24da741 ("Bluetooth: serialize accept_q access") serialises the
accept_q list/poll and takes temporary refs inside bt_accept_dequeue(),
and CVE-2025-39860 serialises the userspace close()/accept() race by
calling cleanup_listen() under lock_sock() in l2cap_sock_release().
Neither covers l2cap_conn_del() running from hci_rx_work, so this UAF
still reproduces on current bluetooth/master.
Take the reference at the source: bt_accept_dequeue() does sock_hold()
while sk is still locked, before release_sock(); callers sock_put().
cleanup_listen() pins the chan with l2cap_chan_hold_unless_zero() under
a brief child sk lock (serialising vs l2cap_sock_teardown_cb()), drops
it before l2cap_chan_lock(), and skips a duplicate l2cap_sock_kill() on
SOCK_DEAD. conn->lock is not taken here: cleanup_listen() runs under
the parent sk lock and that would invert
conn->lock -> chan->lock -> sk_lock (lockdep).
KASAN/SMP: an unprivileged listen/close vs HCI-disconnect race produced
12 use-after-free reports per run before this change; 0, and no lockdep
report, over 1600+ raced iterations after it on bluetooth/master.
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: use chan timer to close channels in cleanup_listen()
l2cap_chan_close() removes the channel from conn->chan_l, which
must be done under conn->lock. cleanup_listen() runs under the
parent sk_lock, so acquiring conn->lock would invert the
established conn->lock -> chan->lock -> sk_lock order.
Instead of calling l2cap_chan_close() directly, schedule
l2cap_chan_timeout with delay 0 to close the channel
asynchronously. The timeout handler already acquires conn->lock
and chan->lock in the correct order.
The timer is only armed when chan->conn is still set: if it is
already NULL, l2cap_conn_del() has already processed this channel
(l2cap_chan_del + l2cap_sock_teardown_cb + l2cap_sock_close_cb),
so there is nothing left to do. If l2cap_conn_del() races in
after the timer is armed, __clear_chan_timer() inside
l2cap_chan_del() cancels it; if the timer has already fired, the
handler returns harmlessly because chan->conn was cleared.