Linux: >> Linux Kernel >> 6.1.29 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
NFSD: Fix SECINFO_NO_NAME decode error cleanup
nfsd4_decode_secinfo_no_name() currently initializes sin_exp after
decoding sin_style. If the XDR stream is truncated, the decoder returns
nfserr_bad_xdr before sin_exp is initialized.
Since commit 3fdc54646234 ("NFSD: Reduce amount of struct
nfsd4_compoundargs that needs clearing"), the inline iops array is not
cleared between RPC calls. A failed SECINFO_NO_NAME decode can therefore
leave sin_exp holding stale union contents from a previous operation.
The error response path still invokes nfsd4_secinfo_no_name_release(),
which calls exp_put() on a non-NULL sin_exp.
Initialize sin_exp before the first failable decode step, matching
nfsd4_decode_secinfo().
CVSS Score
9.8
EPSS Score
0.005
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
serial: 8250_dw: unregister 8250 port if clk_notifier_register() fails
dw8250_probe() registers the 8250 port via serial8250_register_8250_port()
and then, if the device has a clock, registers a clock notifier. If
clk_notifier_register() fails, probe returns the error but leaves the
8250 port registered. The matching serial8250_unregister_port() lives
in dw8250_remove(), which is not called when probe fails, so the port
slot stays occupied until the device is rebound or the system is
rebooted. The devm-allocated driver data is freed while the port still
references it (via the saved private_data and serial_in/serial_out
callbacks), so any access to that port slot before a rebind is a
use-after-free hazard.
Unregister the port on the clk_notifier_register() error path.
CVSS Score
9.8
EPSS Score
0.005
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
fuse: re-lock request before replacing page cache folio
fuse_try_move_folio() unlocks the request on entry but does not
re-lock it on the success path. This means fuse_chan_abort() can end the
request and free the fuse_io_args (eg fuse_readpages_end()) while the
subsequent copy chain logic after fuse_try_move_folio() accesses the
fuse_io_args, leading to use-after-free issues.
Fix this by calling lock_request() before replace_page_cache_folio().
This ensures the request is locked on the success path which will
prevent the fuse_io_args from being freed while the later copying logic
runs, and also ensures that the ap->folios[i]->mapping is never null
since ap->folios[i] will always point to the newfolio after
replace_page_cache_folio().
CVSS Score
7.8
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
media: vidtv: fix NULL pointer dereference in vidtv_mux_push_si
syzbot reported a general protection fault in
vidtv_psi_ts_psi_write_into [1].
vidtv_mux_get_pid_ctx() can return NULL, but vidtv_mux_push_si() does
not check for this before dereferencing the returned pointer to access
the continuity counter. This leads to a general protection fault when
accessing a near-NULL address.
The root cause is that vidtv_mux_pid_ctx_init() does not check the
return value of vidtv_mux_create_pid_ctx_once() for PMT section PIDs.
If the allocation fails, the PID context is never created, but init
returns success. The subsequent vidtv_mux_push_si() call then gets
NULL from vidtv_mux_get_pid_ctx() and crashes.
Fix both the root cause (add error check in vidtv_mux_pid_ctx_init
for PMT PIDs) and add defensive NULL checks in vidtv_mux_push_si for
all vidtv_mux_get_pid_ctx() calls.
[1]
Oops: general protection fault, probably for non-canonical address 0xdffffc0000000000: 0000 [#1] SMP KASAN PTI
KASAN: null-ptr-deref in range [0x0000000000000000-0x0000000000000007]
Workqueue: events vidtv_mux_tick
RIP: 0010:vidtv_psi_ts_psi_write_into+0x54a/0xbc0 drivers/media/test-drivers/vidtv/vidtv_psi.c:197
Call Trace:
<TASK>
vidtv_psi_table_header_write_into drivers/media/test-drivers/vidtv/vidtv_psi.c:799 [inline]
vidtv_psi_pmt_write_into+0x3b2/0xa70 drivers/media/test-drivers/vidtv/vidtv_psi.c:1231
vidtv_mux_push_si+0x932/0xe80 drivers/media/test-drivers/vidtv/vidtv_mux.c:196
vidtv_mux_tick+0xe9b/0x1480 drivers/media/test-drivers/vidtv/vidtv_mux.c:408
CVSS Score
5.5
EPSS Score
0.002
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
media: i2c: ov8856: free control handler on error in ov8856_init_controls()
The control handler wasn't freed if adding controls failed, add an error
exit label and convert the existing error return to use it.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: zero-initialize GART table on allocation
GART TLB is flushed after unmapping but not after mapping. Since
amdgpu_bo_create_kernel() does not zero-initialize the buffer, when a
single PTE is written the TLB may speculatively load other uninitialized
entries from the same cacheline. Those garbage entries can appear valid,
and a subsequent write to another PTE in the same cacheline may cause the
GPU to use a stale garbage PTE from the TLB.
Fix this by calling memset_io() to zero-initialize the GART table with
gart_pte_flags immediately after allocation.
Using AMDGPU_GEM_CREATE_VRAM_CLEARED, SDMA-based clear will not work
since SDMA needs GART to be initialized to work.
(cherry picked from commit d9af8263b82b6eaa60c5718e0c6631c5037e4b24)
CVSS Score
8.8
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/vce: Prevent partial address patches
In the case that only one of lo/hi is valid, the patching could result
in a bad address written to in FW.
CVSS Score
8.8
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Add upper bound check for num_of_nodes
drm/amdkfd: Add upper bound check for num_of_nodes
in kfd_ioctl_get_process_apertures_new.
(cherry picked from commit 98ff46a5ea090c14d2cdb4f5b993b05d74f3949f)
CVSS Score
5.5
EPSS Score
0.002
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
drm/msm: always recover the gpu
Previously, in case there was no more work to do, recover worker
wouldn't trigger recovery and would instead rely on the gpu going to
sleep and then resuming when more work is submitted.
Recover_worker will first increment the fence of the hung ring so, if
there's only one job submitted to a ring and that causes an hang, it
will early out.
There's no guarantee that the gpu will suspend and resume before more
work is submitted and if the gpu is in a hung state it will stay in that
state and probably trigger a timeout again.
Just stop checking and always recover the gpu.
Patchwork: https://patchwork.freedesktop.org/patch/704066/
CVSS Score
5.5
EPSS Score
0.002
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
udf: reject descriptors with oversized CRC length
udf_read_tagged() skips CRC verification when descCRCLength +
sizeof(struct tag) exceeds the block size. A crafted UDF image can
set descCRCLength to an oversized value to bypass CRC validation
entirely; the descriptor is then accepted based solely on the 8-bit
tag checksum, which is trivially recomputable.
Reject such descriptors instead of silently accepting them. A
legitimate single-block descriptor should never have a CRC length that
exceeds the block.
CVSS Score
8.4
EPSS Score
0.001
Published
2026-07-19