A vulnerability in the TrustSec CLI parser of Cisco IOS and Cisco IOS XE Software could allow an authenticated, remote attacker to cause an affected device to reload. This vulnerability is due to an improper interaction between the web UI and the CLI parser. An attacker could exploit this vulnerability by requesting a particular CLI command to be run through the web UI. A successful exploit could allow the attacker to cause the device to reload, resulting in a denial of service (DoS) condition.
A vulnerability in the Link Layer Discovery Protocol (LLDP) message parser of Cisco IOS Software and Cisco IOS XE Software could allow an attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. This vulnerability is due to improper initialization of a buffer. An attacker could exploit this vulnerability via any of the following methods: An authenticated, remote attacker could access the LLDP neighbor table via either the CLI or SNMP while the device is in a specific state. An unauthenticated, adjacent attacker could corrupt the LLDP neighbor table by injecting specific LLDP frames into the network and then waiting for an administrator of the device or a network management system (NMS) managing the device to retrieve the LLDP neighbor table of the device via either the CLI or SNMP. An authenticated, adjacent attacker with SNMP read-only credentials or low privileges on the device CLI could corrupt the LLDP neighbor table by injecting specific LLDP frames into the network and then accessing the LLDP neighbor table via either the CLI or SNMP. A successful exploit could allow the attacker to cause the affected device to crash, resulting in a reload of the device.
A vulnerability in the Internet Key Exchange Version 2 (IKEv2) support for the AutoReconnect feature of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, remote attacker to exhaust the free IP addresses from the assigned local pool. This vulnerability occurs because the code does not release the allocated IP address under certain failure conditions. An attacker could exploit this vulnerability by trying to connect to the device with a non-AnyConnect client. A successful exploit could allow the attacker to exhaust the IP addresses from the assigned local pool, which prevents users from logging in and leads to a denial of service (DoS) condition.
A vulnerability in Address Resolution Protocol (ARP) management of Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to prevent an affected device from resolving ARP entries for legitimate hosts on the connected subnets. This vulnerability exists because ARP entries are mismanaged. An attacker could exploit this vulnerability by continuously sending traffic that results in incomplete ARP entries. A successful exploit could allow the attacker to cause ARP requests on the device to be unsuccessful for legitimate hosts, resulting in a denial of service (DoS) condition.
A vulnerability in the web UI of Cisco IOS and Cisco IOS XE Software could allow an unauthenticated, remote attacker to conduct a cross-site request forgery (CSRF) attack on an affected system. The vulnerability is due to insufficient CSRF protections for the web UI on an affected device. An attacker could exploit this vulnerability by persuading a user of the interface to follow a malicious link. A successful exploit could allow the attacker to perform arbitrary actions with the privilege level of the targeted user. If the user has administrative privileges, the attacker could alter the configuration, execute commands, or reload an affected device.
Multiple vulnerabilities in the implementation of the Common Industrial Protocol (CIP) feature of Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition. The vulnerabilities are due to insufficient input processing of CIP traffic. An attacker could exploit these vulnerabilities by sending crafted CIP traffic to be processed by an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition.
A vulnerability in the FTP application layer gateway (ALG) functionality used by Network Address Translation (NAT), NAT IPv6 to IPv4 (NAT64), and the Zone-Based Policy Firewall (ZBFW) in Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload. The vulnerability is due to a buffer overflow that occurs when an affected device inspects certain FTP traffic. An attacker could exploit this vulnerability by performing a specific FTP transfer through the device. A successful exploit could allow the attacker to cause the device to reload.
A vulnerability in the logic that handles access control to one of the hardware components in Cisco's proprietary Secure Boot implementation could allow an authenticated, local attacker to write a modified firmware image to the component. This vulnerability affects multiple Cisco products that support hardware-based Secure Boot functionality. The vulnerability is due to an improper check on the area of code that manages on-premise updates to a Field Programmable Gate Array (FPGA) part of the Secure Boot hardware implementation. An attacker with elevated privileges and access to the underlying operating system that is running on the affected device could exploit this vulnerability by writing a modified firmware image to the FPGA. A successful exploit could either cause the device to become unusable (and require a hardware replacement) or allow tampering with the Secure Boot verification process, which under some circumstances may allow the attacker to install and boot a malicious software image. An attacker will need to fulfill all the following conditions to attempt to exploit this vulnerability: Have privileged administrative access to the device. Be able to access the underlying operating system running on the device; this can be achieved either by using a supported, documented mechanism or by exploiting another vulnerability that would provide an attacker with such access. Develop or have access to a platform-specific exploit. An attacker attempting to exploit this vulnerability across multiple affected platforms would need to research each one of those platforms and then develop a platform-specific exploit. Although the research process could be reused across different platforms, an exploit developed for a given hardware platform is unlikely to work on a different hardware platform.
A vulnerability in the Cisco IOS Software and Cisco IOS XE Software function that restores encapsulated option 82 information in DHCP Version 4 (DHCPv4) packets could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a Relay Reply denial of service (DoS) condition. The vulnerability exists because the affected software performs incomplete input validation of encapsulated option 82 information that it receives in DHCPOFFER messages from DHCPv4 servers. An attacker could exploit this vulnerability by sending a crafted DHCPv4 packet to an affected device, which the device would then forward to a DHCPv4 server. When the affected software processes the option 82 information that is encapsulated in the response from the server, an error could occur. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. Cisco Bug IDs: CSCvg62754.
A vulnerability in the DHCP option 82 encapsulation functionality of Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition. The vulnerability exists because the affected software performs incomplete input validation of option 82 information that it receives in DHCP Version 4 (DHCPv4) packets from DHCP relay agents. An attacker could exploit this vulnerability by sending a crafted DHCPv4 packet to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. Cisco Bug IDs: CSCuh91645.