Linux: >> Linux Kernel >> 2.6.28.8 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: io_ti: fix heap overflow in get_manuf_info()
get_manuf_info() reads le16_to_cpu(rom_desc->Size) bytes from the
device I2C EEPROM into a buffer allocated with kmalloc_obj(), which
is sizeof(struct edge_ti_manuf_descriptor) = 10 bytes.
The Size field comes from the device and is only validated (in
check_i2c_image()) to make sure the descriptor fits within
TI_MAX_I2C_SIZE (16384 bytes), not against the destination buffer size.
A malicious USB device can therefore set Size to any value up to 16377,
causing a heap overflow of up to 16367 bytes when plugged into a host
running this driver.
valid_csum() is called after read_rom() and also iterates
buffer[0..Size-1], compounding the out-of-bounds access.
Fix by rejecting descriptors with unexpected length before calling
read_rom().
[ johan: amend commit message; also check for short descriptors ]
CVSS Score
6.8
EPSS Score
0.003
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
RDMA/srp: bound SRP_RSP sense copy by the received length
srp_process_rsp() copies sense data from rsp->data + resp_data_len,
where resp_data_len is the full 32-bit value supplied by the SRP target
and is never checked against the number of bytes actually received
(wc->byte_len). The copy length is bounded to SCSI_SENSE_BUFFERSIZE, so
at most 96 bytes are copied, but the source offset is not bounded.
A malicious or compromised SRP target on the InfiniBand/RoCE fabric that
the initiator has logged into can return an SRP_RSP with
SRP_RSP_FLAG_SNSVALID set and a large resp_data_len. The receive buffer
is allocated at the target-chosen max_ti_iu_len, so the source of the
sense copy lands past the bytes actually received; with resp_data_len
near 0xFFFFFFFF it is gigabytes past the buffer and the read faults.
Copy the sense data only if it has not been truncated, that is, only if
the response header, the response data, and the sense region fit within
the bytes actually received; otherwise drop the sense and log. The
in-tree iSER and NVMe-RDMA receive paths already bound their parse by
wc->byte_len; this brings ib_srp into line with them.
CVSS Score
9.1
EPSS Score
0.005
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: io_ti: fix heap overflow in build_i2c_fw_hdr()
build_i2c_fw_hdr() allocates a fixed-size buffer of
(16*1024 - 512) + sizeof(struct ti_i2c_firmware_rec) bytes, then
copies le16_to_cpu(img_header->Length) bytes into it without
validating that Length fits within the available space after the
firmware record header.
img_header->Length is a __le16 from the firmware file and can be
up to 65535. check_fw_sanity() validates the total firmware size
but not img_header->Length specifically.
Fix by rejecting images where img_header->Length exceeds the
available destination space.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
netfilter: require Ethernet MAC header before using eth_hdr()
`ip6t_eui64`, `xt_mac`, the `bitmap:ip,mac`, `hash:ip,mac`, and
`hash:mac` ipset types, and `nf_log_syslog` access `eth_hdr(skb)`
after either assuming that the skb is associated with an Ethernet
device or checking only that the `ETH_HLEN` bytes at
`skb_mac_header(skb)` lie between `skb->head` and `skb->data`.
Make these paths first verify that the skb is associated with an
Ethernet device, that the MAC header was set, and that it spans at
least a full Ethernet header before accessing `eth_hdr(skb)`.
CVSS Score
9.4
EPSS Score
0.004
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
fs/omfs: reject s_sys_blocksize smaller than OMFS_DIR_START
omfs_fill_super() rejects oversized s_sys_blocksize values (> PAGE_SIZE),
but it does not reject values smaller than OMFS_DIR_START (0x1b8 = 440).
Later, omfs_make_empty() uses
sbi->s_sys_blocksize - OMFS_DIR_START
as the length argument to memset(). Since s_sys_blocksize is u32,
a crafted filesystem image with s_sys_blocksize < OMFS_DIR_START causes
an unsigned underflow there, wrapping to a value near 2^32. That drives
a ~4 GiB memset() from bh->b_data + OMFS_DIR_START and overwrites kernel
memory far beyond the backing block buffer.
Add the corresponding lower-bound check alongside the existing upper-bound
check in omfs_fill_super(), so that malformed images are rejected during
superblock validation before any filesystem data is processed.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
net: hamradio: 6pack: fix uninit-value in sixpack_receive_buf
sixpack_receive_buf() does not properly skip bytes with TTY error flags.
The while loop iterates through the flags buffer but never advances the
data pointer (cp), and passes the original count (including error bytes)
to sixpack_decode(). This causes sixpack_decode() to process bytes that
should have been skipped due to TTY errors. The TTY layer does not
guarantee that cp[i] holds a meaningful value when fp[i] is set, so
passing those positions to sixpack_decode() results in KMSAN reporting
an uninit-value read.
Fix this by processing bytes one at a time, advancing cp on each
iteration, and only passing valid (non-error) bytes to sixpack_decode().
This matches the pattern used by slip_receive_buf() and
mkiss_receive_buf() for the same purpose.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
dm log: fix out-of-bounds write due to region_count overflow
The local variable region_count in create_log_context() is declared as
unsigned int (32-bit), but dm_sector_div_up() returns sector_t (64-bit).
When a device-mapper target has a sufficiently large ti->len with a small
region_size, the division result can exceed UINT_MAX. The truncated
value is then used to calculate bitset_size, causing clean_bits,
sync_bits, and recovering_bits to be allocated far smaller than needed
for the actual number of regions.
Subsequent log operations (log_set_bit, log_clear_bit, log_test_bit) use
region indices derived from the full untruncated region space, causing
out-of-bounds writes to kernel heap memory allocated by vmalloc.
This can be reproduced by creating a mirror target whose region_count
overflows 32 bits:
dmsetup create bigzero --table '0 8589934594 zero'
dmsetup create mymirror --table '0 8589934594 mirror \
core 2 2 nosync 2 /dev/mapper/bigzero 0 \
/dev/mapper/bigzero 0'
The status output confirms the truncation (sync_count=1 instead of
4294967297, because 0x100000001 was truncated to 1):
$ dmsetup status mymirror
0 8589934594 mirror 2 254:1 254:1 1/4294967297 ...
This leads to a kernel crash in core_in_sync:
BUG: scheduling while atomic: (udev-worker)/9150/0x00000000
RIP: 0010:core_in_sync+0x14/0x30 [dm_log]
CR2: 0000000000000008
Fixing recursive fault but reboot is needed!
Fix by widening the local region_count to sector_t and adding an
explicit overflow check before the value is assigned to lc->region_count.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: validate group add input before caching
[BUG]
OCFS2_IOC_GROUP_ADD can trigger a BUG_ON in
ocfs2_set_new_buffer_uptodate():
kernel BUG at fs/ocfs2/uptodate.c:509!
Oops: invalid opcode: 0000 [#1] SMP KASAN NOPTI
RIP: 0010:ocfs2_set_new_buffer_uptodate+0x194/0x1e0 fs/ocfs2/uptodate.c:509
Code: ffffe88f 42b9fe4c 89e64889 dfe8b4df
Call Trace:
ocfs2_group_add+0x3f1/0x1510 fs/ocfs2/resize.c:507
ocfs2_ioctl+0x309/0x6e0 fs/ocfs2/ioctl.c:887
vfs_ioctl fs/ioctl.c:51 [inline]
__do_sys_ioctl fs/ioctl.c:597 [inline]
__se_sys_ioctl fs/ioctl.c:583 [inline]
__x64_sys_ioctl+0x197/0x1e0 fs/ioctl.c:583
x64_sys_call+0x1144/0x26a0 arch/x86/include/generated/asm/syscalls_64.h:17
do_syscall_x64 arch/x86/entry/syscall_64.c:63 [inline]
do_syscall_64+0x93/0xf80 arch/x86/entry/syscall_64.c:94
entry_SYSCALL_64_after_hwframe+0x76/0x7e
RIP: 0033:0x7bbfb55a966d
[CAUSE]
ocfs2_group_add() calls ocfs2_set_new_buffer_uptodate() on a
user-controlled group block before ocfs2_verify_group_and_input()
validates that block number. That helper is only valid for newly
allocated metadata and asserts that the block is not already present in
the chosen metadata cache. The code also uses INODE_CACHE(inode) even
though the group descriptor belongs to main_bm_inode and later journal
accesses use that cache context instead.
[FIX]
Validate the on-disk group descriptor before caching it, then add it to
the metadata cache tracked by INODE_CACHE(main_bm_inode). Keep the
validation failure path separate from the later cleanup path so we only
remove the buffer from that cache after it has actually been inserted.
This keeps the group buffer lifetime consistent across validation,
journaling, and cleanup.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: fix listxattr handling when the buffer is full
[BUG]
If an OCFS2 inode has both inline and block-based xattrs, listxattr()
can return a size larger than the caller's buffer when the inline names
consume that buffer exactly.
kernel BUG at mm/usercopy.c:102!
Oops: invalid opcode: 0000 [#1] SMP KASAN NOPTI
RIP: 0010:usercopy_abort+0xb7/0xd0 mm/usercopy.c:102
Call Trace:
__check_heap_object+0xe3/0x120 mm/slub.c:8243
check_heap_object mm/usercopy.c:196 [inline]
__check_object_size mm/usercopy.c:250 [inline]
__check_object_size+0x5c5/0x780 mm/usercopy.c:215
check_object_size include/linux/ucopysize.h:22 [inline]
check_copy_size include/linux/ucopysize.h:59 [inline]
copy_to_user include/linux/uaccess.h:219 [inline]
listxattr+0xb0/0x170 fs/xattr.c:926
filename_listxattr fs/xattr.c:958 [inline]
path_listxattrat+0x137/0x320 fs/xattr.c:988
__do_sys_listxattr fs/xattr.c:1001 [inline]
__se_sys_listxattr fs/xattr.c:998 [inline]
__x64_sys_listxattr+0x7f/0xd0 fs/xattr.c:998
...
[CAUSE]
Commit 936b8834366e ("ocfs2: Refactor xattr list and remove
ocfs2_xattr_handler().") replaced the old per-handler list accounting
with ocfs2_xattr_list_entry(), but it kept using size == 0 to detect
probe mode.
That assumption stops being true once ocfs2_listxattr() finishes the
inline-xattr pass. If the inline names fill the caller buffer exactly,
the block-xattr pass runs with a non-NULL buffer and a remaining size of
zero. ocfs2_xattr_list_entry() then skips the bounds check, keeps
counting block names, and returns a positive size larger than the
supplied buffer.
[FIX]
Detect probe mode by testing whether the destination buffer pointer is
NULL instead of whether the remaining size is zero.
That restores the pre-refactor behavior and matches the OCFS2 getxattr
helpers. Once the remaining buffer reaches zero while more names are
left, the block-xattr pass now returns -ERANGE instead of reporting a
size larger than the allocated list buffer.
CVSS Score
7.1
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
netfilter: xtables: restrict several matches to inet family
This is a partial revert of:
commit ab4f21e6fb1c ("netfilter: xtables: use NFPROTO_UNSPEC in more extensions")
to allow ipv4 and ipv6 only.
- xt_mac
- xt_owner
- xt_physdev
These extensions are not used by ebtables in userspace.
Moreover, xt_realm is only for ipv4, since dst->tclassid is ipv4
specific.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-06-24