Linux: >> Linux Kernel >> 4.4.44 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
wifi: b43legacy: enforce bounds check on firmware key index in RX path
Same fix as b43: the firmware-controlled key index in b43legacy_rx()
can exceed dev->max_nr_keys. The existing B43legacy_WARN_ON is
non-enforcing in production builds, allowing an out-of-bounds read of
dev->key[].
Make the check enforcing by dropping the frame for invalid indices.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: Fix pin leak and publication ordering in __pkvm_init_vcpu()
Two bugs exist in the vCPU initialisation path:
1. If a check fails after hyp_pin_shared_mem() succeeds, the cleanup
path jumps to 'unlock' without calling unpin_host_vcpu() or
unpin_host_sve_state(), permanently leaking pin references on the
host vCPU and SVE state pages.
Extract a register_hyp_vcpu() helper that performs the checks and
the store. When register_hyp_vcpu() returns an error, call
unpin_host_vcpu() and unpin_host_sve_state() inline before falling
through to the existing 'unlock' label.
2. register_hyp_vcpu() publishes the new vCPU pointer into
'hyp_vm->vcpus[]' with a bare store, allowing a concurrent caller
of pkvm_load_hyp_vcpu() to observe a partially initialised vCPU
object.
Ensure the store uses smp_store_release() and the load uses
smp_load_acquire(). While 'vm_table_lock' currently serialises the
store and the load, these barriers ensure the reader sees the fully
initialised 'hyp_vcpu' object even if there were a lockless path or
if the lock's own ordering guarantees were insufficient for nested
object initialization.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
scsi: target: configfs: Bound snprintf() return in tg_pt_gp_members_show()
target_tg_pt_gp_members_show() formats LUN paths with snprintf() into a
256-byte stack buffer, then will memcpy() cur_len bytes from that
buffer. snprintf() returns the length the output would have had, which
can exceed the buffer size when the fabric WWN is long because iSCSI IQN
names can be up to 223 bytes. The check at the memcpy() site only
guards the destination page write, not the source read, so memcpy() will
read past the stack buffer and copy adjacent stack contents to the sysfs
reader, which when CONFIG_FORTIFY_SOURCE is enabled, fortify_panic()
will be triggered.
Commit 27e06650a5ea ("scsi: target: target_core_configfs: Add length
check to avoid buffer overflow") added the same bound to the
target_lu_gp_members_show() but the tg_pt_gp variant was missed so
resolve that here.
CVSS Score
7.1
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
usb: usblp: fix heap leak in IEEE 1284 device ID via short response
usblp_ctrl_msg() collapses the usb_control_msg() return value to
0/-errno, discarding the actual number of bytes transferred. A broken
printer can complete the GET_DEVICE_ID control transfer short and the
driver has no way to know.
usblp_cache_device_id_string() reads the 2-byte big-endian length prefix
from the response and trusts it (clamped only to the buffer bounds).
The buffer is kmalloc(1024) at probe time. A device that sends exactly
two bytes (e.g. 0x03 0xFF, claiming a 1023-byte ID) leaves
device_id_string[2..1022] holding stale kmalloc heap.
That stale data is then exposed:
- via the ieee1284_id sysfs attribute (sprintf("%s", buf+2), truncated
at the first NUL in the stale heap), and
- via the IOCNR_GET_DEVICE_ID ioctl, which copy_to_user()s the full
claimed length regardless of NULs, up to 1021 bytes of uninitialized
heap, with the leak size chosen by the device.
Fix this up by just zapping the buffer with zeros before each request
sent to the device.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
8021q: delete cleared egress QoS mappings
vlan_dev_set_egress_priority() currently keeps cleared egress
priority mappings in the hash as tombstones. Repeated set/clear cycles
with distinct skb priorities therefore accumulate mapping nodes until
device teardown and leak memory.
Delete mappings when vlan_prio is cleared instead of keeping tombstones.
Now that the egress mapping lists are RCU protected, the node can be
unlinked safely and freed after a grace period.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_event: fix potential UAF in SSP passkey handlers
hci_conn lookup and field access must be covered by hdev lock in
hci_user_passkey_notify_evt() and hci_keypress_notify_evt(), otherwise
the connection can be freed concurrently.
Extend the hci_dev_lock critical section to cover all conn usage in both
handlers.
Keep the existing keypress notification behavior unchanged by routing
the early exits through a common unlock path.
CVSS Score
8.8
EPSS Score
0.003
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ALSA: ctxfi: Add fallback to default RSR for S/PDIF
spdif_passthru_playback_get_resources() uses atc->pll_rate as the RSR
for the MSR calculation loop. However, pll_rate is only updated in
atc_pll_init() and not in hw_pll_init(), so it remains 0 after the
card init.
When spdif_passthru_playback_setup() skips atc_pll_init() for
32000 Hz, (rsr * desc.msr) always becomes 0, causing the loop to spin
indefinitely.
Add fallback to use atc->rsr when atc->pll_rate is 0. This reflects
the hardware state, since hw_card_init() already configures the PLL
to the default RSR.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
md/raid5: fix soft lockup in retry_aligned_read()
When retry_aligned_read() encounters an overlapped stripe, it releases
the stripe via raid5_release_stripe() which puts it on the lockless
released_stripes llist. In the next raid5d loop iteration,
release_stripe_list() drains the stripe onto handle_list (since
STRIPE_HANDLE is set by the original IO), but retry_aligned_read()
runs before handle_active_stripes() and removes the stripe from
handle_list via find_get_stripe() -> list_del_init(). This prevents
handle_stripe() from ever processing the stripe to resolve the
overlap, causing an infinite loop and soft lockup.
Fix this by using __release_stripe() with temp_inactive_list instead
of raid5_release_stripe() in the failure path, so the stripe does not
go through the released_stripes llist. This allows raid5d to break out
of its loop, and the overlap will be resolved when the stripe is
eventually processed by handle_stripe().
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ceph: only d_add() negative dentries when they are unhashed
Ceph can call d_add(dentry, NULL) on a negative dentry that is already
present in the primary dcache hash.
In the current VFS that is not safe. d_add() goes through __d_add()
to __d_rehash(), which unconditionally reinserts dentry->d_hash into
the hlist_bl bucket. If the dentry is already hashed, reinserting the
same node can corrupt the bucket, including creating a self-loop.
Once that happens, __d_lookup() can spin forever in the hlist_bl walk,
typically looping only on the d_name.hash mismatch check and
eventually triggering RCU stall reports like this one:
rcu: INFO: rcu_sched self-detected stall on CPU
rcu: 87-....: (2100 ticks this GP) idle=3a4c/1/0x4000000000000000 softirq=25003319/25003319 fqs=829
rcu: (t=2101 jiffies g=79058445 q=698988 ncpus=192)
CPU: 87 UID: 2952868916 PID: 3933303 Comm: php-cgi8.3 Not tainted 6.18.17-i1-amd #950 NONE
Hardware name: Dell Inc. PowerEdge R7615/0G9DHV, BIOS 1.6.6 09/22/2023
RIP: 0010:__d_lookup+0x46/0xb0
Code: c1 e8 07 48 8d 04 c2 48 8b 00 49 89 fc 49 89 f5 48 89 c3 48 83 e3 fe 48 83 f8 01 77 0f eb 2d 0f 1f 44 00 00 48 8b 1b 48 85 db <74> 20 39 6b 18 75 f3 48 8d 7b 78 e8 ba 85 d0 00 4c 39 63 10 74 1f
RSP: 0018:ff745a70c8253898 EFLAGS: 00000282
RAX: ff26e470054cb208 RBX: ff26e470054cb208 RCX: 000000006e958966
RDX: ff26e48267340000 RSI: ff745a70c82539b0 RDI: ff26e458f74655c0
RBP: 000000006e958966 R08: 0000000000000180 R09: 9cd08d909b919a89
R10: ff26e458f74655c0 R11: 0000000000000000 R12: ff26e458f74655c0
R13: ff745a70c82539b0 R14: d0d0d0d0d0d0d0d0 R15: 2f2f2f2f2f2f2f2f
FS: 00007f5770896980(0000) GS:ff26e482c5d88000(0000) knlGS:0000000000000000
CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
CR2: 00007f5764de50c0 CR3: 000000a72abb5001 CR4: 0000000000771ef0
PKRU: 55555554
Call Trace:
<TASK>
lookup_fast+0x9f/0x100
walk_component+0x1f/0x150
link_path_walk+0x20e/0x3d0
path_lookupat+0x68/0x180
filename_lookup+0xdc/0x1e0
vfs_statx+0x6c/0x140
vfs_fstatat+0x67/0xa0
__do_sys_newfstatat+0x24/0x60
do_syscall_64+0x6a/0x230
entry_SYSCALL_64_after_hwframe+0x76/0x7e
This is reachable with reused cached negative dentries. A Ceph lookup
or atomic_open can be handed a negative dentry that is already hashed,
and fs/ceph/dir.c then hits one of two paths that incorrectly assume
"negative" also means "unhashed":
- ceph_finish_lookup():
MDS reply is -ENOENT with no trace
-> d_add(dentry, NULL)
- ceph_lookup():
local ENOENT fast path for a complete directory with shared caps
-> d_add(dentry, NULL)
Both paths can therefore re-add an already-hashed negative dentry.
Ceph already uses the correct pattern elsewhere: ceph_fill_trace() only
calls d_add(dn, NULL) for a negative null-dentry reply when d_unhashed(dn)
is true.
Fix both fs/ceph/dir.c sites the same way: only call d_add() for a
negative dentry when it is actually unhashed. If the negative dentry
is already hashed, leave it in place and reuse it as-is.
This preserves the existing behavior for unhashed dentries while
avoiding d_hash list corruption for reused hashed negatives.
CVSS Score
7.5
EPSS Score
0.004
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ipmi:ssif: Clean up kthread on errors
If an error occurs after the ssif kthread is created, but before the
main IPMI code starts the ssif interface, the ssif kthread will not
be stopped.
So make sure the kthread is stopped on an error condition if it is
running.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27