Linux: >> Linux Kernel >> 2.6.22.21 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
dm log: fix out-of-bounds write due to region_count overflow
The local variable region_count in create_log_context() is declared as
unsigned int (32-bit), but dm_sector_div_up() returns sector_t (64-bit).
When a device-mapper target has a sufficiently large ti->len with a small
region_size, the division result can exceed UINT_MAX. The truncated
value is then used to calculate bitset_size, causing clean_bits,
sync_bits, and recovering_bits to be allocated far smaller than needed
for the actual number of regions.
Subsequent log operations (log_set_bit, log_clear_bit, log_test_bit) use
region indices derived from the full untruncated region space, causing
out-of-bounds writes to kernel heap memory allocated by vmalloc.
This can be reproduced by creating a mirror target whose region_count
overflows 32 bits:
dmsetup create bigzero --table '0 8589934594 zero'
dmsetup create mymirror --table '0 8589934594 mirror \
core 2 2 nosync 2 /dev/mapper/bigzero 0 \
/dev/mapper/bigzero 0'
The status output confirms the truncation (sync_count=1 instead of
4294967297, because 0x100000001 was truncated to 1):
$ dmsetup status mymirror
0 8589934594 mirror 2 254:1 254:1 1/4294967297 ...
This leads to a kernel crash in core_in_sync:
BUG: scheduling while atomic: (udev-worker)/9150/0x00000000
RIP: 0010:core_in_sync+0x14/0x30 [dm_log]
CR2: 0000000000000008
Fixing recursive fault but reboot is needed!
Fix by widening the local region_count to sector_t and adding an
explicit overflow check before the value is assigned to lc->region_count.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
netfilter: conntrack: remove sprintf usage
Replace it with scnprintf, the buffer sizes are expected to be large enough
to hold the result, no need for snprintf+overflow check.
Increase buffer size in mangle_content_len() while at it.
BUG: KASAN: stack-out-of-bounds in vsnprintf+0xea5/0x1270
Write of size 1 at addr [..]
vsnprintf+0xea5/0x1270
sprintf+0xb1/0xe0
mangle_content_len+0x1ac/0x280
nf_nat_sdp_session+0x1cc/0x240
process_sdp+0x8f8/0xb80
process_invite_request+0x108/0x2b0
process_sip_msg+0x5da/0xf50
sip_help_tcp+0x45e/0x780
nf_confirm+0x34d/0x990
[..]
CVSS Score
9.8
EPSS Score
0.004
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
net: usb: rtl8150: fix use-after-free in rtl8150_start_xmit()
syzbot reported a KASAN slab-use-after-free read in rtl8150_start_xmit()
when accessing skb->len for tx statistics after usb_submit_urb() has
been called:
BUG: KASAN: slab-use-after-free in rtl8150_start_xmit+0x71f/0x760
drivers/net/usb/rtl8150.c:712
Read of size 4 at addr ffff88810eb7a930 by task kworker/0:4/5226
The URB completion handler write_bulk_callback() frees the skb via
dev_kfree_skb_irq(dev->tx_skb). The URB may complete on another CPU
in softirq context before usb_submit_urb() returns in the submitter,
so by the time the submitter reads skb->len the skb has already been
queued to the per-CPU completion_queue and freed by net_tx_action():
CPU A (xmit) CPU B (USB completion softirq)
------------ ------------------------------
dev->tx_skb = skb;
usb_submit_urb() --+
|-------> write_bulk_callback()
| dev_kfree_skb_irq(dev->tx_skb)
| net_tx_action()
| napi_skb_cache_put() <-- free
netdev->stats.tx_bytes |
+= skb->len; <-- UAF read
Fix it by caching skb->len before submitting the URB and using the
cached value when updating the tx_bytes counter.
The pre-existing tx_bytes semantics are preserved: the counter tracks
the original frame length (skb->len), not the ETH_ZLEN/USB-alignment
padded "count" value that is handed to the device. Changing that
would be a user-visible accounting change and is out of scope for
this UAF fix.
CVSS Score
9.8
EPSS Score
0.005
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
fs/fcntl: fix SOFTIRQ-unsafe lock order in fasync signaling
A SOFTIRQ-safe to SOFTIRQ-unsafe lock order deadlock can occur in
send_sigio() and send_sigurg() when a process group receives a signal.
When FASYNC is configured for a process group (PIDTYPE_PGID), both
functions use read_lock(&tasklist_lock) to traverse the task list.
However, they are frequently called from softirq context:
- send_sigio() via input_inject_event -> kill_fasync
- send_sigurg() via tcp_check_urg -> sk_send_sigurg (NET_RX_SOFTIRQ)
The deadlock is caused by the rwlock writer fairness mechanism:
1. CPU 0 (process context) holds read_lock(&tasklist_lock) in do_wait().
2. CPU 1 (process context) attempts write_lock(&tasklist_lock) in
fork() or exit() and spins, which blocks all new readers.
3. CPU 0 is interrupted by a softirq (e.g., TCP URG packet reception).
4. The softirq calls send_sigurg() and attempts to acquire
read_lock(&tasklist_lock), deadlocking because CPU 1 is waiting.
Since PID hashing and do_each_pid_task() traversals are already
RCU-protected, the read_lock on tasklist_lock is no longer strictly
required for safe traversal. Fix this by replacing tasklist_lock with
rcu_read_lock(), aligning the process group signaling path with the
single-PID path. This also mitigates a potential remote denial of
service vector via TCP URG packets.
Lockdep splat:
=====================================================
WARNING: SOFTIRQ-safe -> SOFTIRQ-unsafe lock order detected
[...]
Chain exists of:
&dev->event_lock --> &f_owner->lock --> tasklist_lock
Possible interrupt unsafe locking scenario:
CPU0 CPU1
---- ----
lock(tasklist_lock);
local_irq_disable();
lock(&dev->event_lock);
lock(&f_owner->lock);
<Interrupt>
lock(&dev->event_lock);
*** DEADLOCK ***
CVSS Score
7.5
EPSS Score
0.005
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
netfilter: ip6t_hbh: reject oversized option lists
struct ip6t_opts stores at most IP6T_OPTS_OPTSNR option descriptors,
but hbh_mt6_check() does not reject larger optsnr values supplied from
userspace.
Validate optsnr in the rule setup path so only match data that fits the
fixed-size opts array can be installed. This follows the existing xtables
pattern of rejecting invalid user-provided counts in checkentry() and
keeps the packet matching path unchanged.
`struct ip6t_opts` has a fixed `opts[IP6T_OPTS_OPTSNR]` array,
where `IP6T_OPTS_OPTSNR` is 16, then off-by-one array access is possible:
[ 137.924693][ T8692] UBSAN: array-index-out-of-bounds in ../net/ipv6/netfilter/ip6t_hbh.c:110:29
[ 137.926167][ T8692] index 16 is out of range for type '__u16 [16]'
CVSS Score
7.1
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: serialize accept_q access
bt_sock_poll() walks the accept queue without synchronization, while
child teardown can unlink the same socket and drop its last reference.
The unsynchronized accept queue walk has existed since the initial
Bluetooth import.
Protect accept_q with a dedicated lock for queue updates and polling.
Also rework bt_accept_dequeue() to take temporary child references under
the queue lock before dropping it and locking the child socket.
CVSS Score
8.8
EPSS Score
0.003
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_policy: fix strict mode inbound policy matching
match_policy_in() walks sec_path entries from the last transform to the
first one, but strict policy matching needs to consume info->pol[] in
the same forward order as the rule layout.
Derive the strict-match policy position from the number of transforms
already consumed so that multi-element inbound rules are matched
consistently.
CVSS Score
8.3
EPSS Score
0.003
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
dm: fix a buffer overflow in ioctl processing
Tony Asleson (using Claude) found a buffer overflow in dm-ioctl in the
function retrieve_status:
1. The code in retrieve_status checks that the output string fits into
the output buffer and writes the output string there
2. Then, the code aligns the "outptr" variable to the next 8-byte
boundary:
outptr = align_ptr(outptr);
3. The alignment doesn't check overflow, so outptr could point past the
buffer end
4. The "for" loop is iterated again, it executes:
remaining = len - (outptr - outbuf);
5. If "outptr" points past "outbuf + len", the arithmetics wraps around
and the variable "remaining" contains unusually high number
6. With "remaining" being high, the code writes more data past the end of
the buffer
Luckily, this bug has no security implications because:
1. Only root can issue device mapper ioctls
2. The commonly used libraries that communicate with device mapper
(libdevmapper and devicemapper-rs) use buffer size that is aligned to
8 bytes - thus, "outptr = align_ptr(outptr)" can't overshoot the input
buffer and the bug can't happen accidentally
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-08
In the Linux kernel, the following vulnerability has been resolved:
inet: RAW sockets using IPPROTO_RAW MUST drop incoming ICMP
Yizhou Zhao reported that simply having one RAW socket on protocol
IPPROTO_RAW (255) was dangerous.
socket(AF_INET, SOCK_RAW, 255);
A malicious incoming ICMP packet can set the protocol field to 255
and match this socket, leading to FNHE cache changes.
inner = IP(src="192.168.2.1", dst="8.8.8.8", proto=255)/Raw("TEST")
pkt = IP(src="192.168.1.1", dst="192.168.2.1")/ICMP(type=3, code=4, nexthopmtu=576)/inner
"man 7 raw" states:
A protocol of IPPROTO_RAW implies enabled IP_HDRINCL and is able
to send any IP protocol that is specified in the passed header.
Receiving of all IP protocols via IPPROTO_RAW is not possible
using raw sockets.
Make sure we drop these malicious packets.
CVSS Score
9.1
EPSS Score
0.003
Published
2026-06-03
In the Linux kernel, the following vulnerability has been resolved:
fbcon: Avoid OOB font access if console rotation fails
Clear the font buffer if the reallocation during console rotation fails
in fbcon_rotate_font(). The putcs implementations for the rotated buffer
will return early in this case. See [1] for an example.
Currently, fbcon_rotate_font() keeps the old buffer, which is too small
for the rotated font. Printing to the rotated console with a high-enough
character code will overflow the font buffer.
v2:
- fix typos in commit message
CVSS Score
7.1
EPSS Score
0.001
Published
2026-05-28