Linux: >> Linux Kernel >> 4.2.4 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: stop parsing UAC2 rates at MAX_NR_RATES
parse_uac2_sample_rate_range() caps the number of enumerated
rates at MAX_NR_RATES, but it only breaks out of the current
rate loop. A malformed UAC2 RANGE response with additional
triplets continues parsing the remaining triplets and repeatedly
prints "invalid uac2 rates" while probe still holds
register_mutex.
Stop the whole parse once the cap is reached and return the
number of rates collected so far.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
thermal: core: Fix thermal zone governor cleanup issues
If thermal_zone_device_register_with_trips() fails after adding
a thermal governor to the thermal zone being registered, the
governor is not removed from it as appropriate which may lead to
a memory leak.
In turn, thermal_zone_device_unregister() calls thermal_set_governor()
without acquiring the thermal zone lock beforehand which may race with
a governor update via sysfs and may lead to a use-after-free in that
case.
Address these issues by adding two thermal_set_governor() calls, one to
thermal_release() to remove the governor from the given thermal zone,
and one to the thermal zone registration error path to cover failures
preceding the thermal zone device registration.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
misc: ibmasm: fix OOB MMIO read in ibmasm_handle_mouse_interrupt()
ibmasm_handle_mouse_interrupt() performs an out-of-bounds MMIO read
when the queue reader or writer index from hardware exceeds
REMOTE_QUEUE_SIZE (60).
A compromised service processor can trigger this by writing an
out-of-range value to the reader or writer MMIO register before
asserting an interrupt. Since writer is re-read from hardware on
every loop iteration, it can also be set to an out-of-range value
after the loop has already started.
The root cause is that get_queue_reader() and get_queue_writer() return
raw readl() values that are passed directly into get_queue_entry(),
which computes:
queue_begin + reader * sizeof(struct remote_input)
with no bounds check. This unchecked MMIO address is then passed to
memcpy_fromio(), reading 8 bytes from unintended device registers.
For sufficiently large values the address falls outside the PCI BAR
mapping entirely, triggering a machine check exception.
Fix by checking both indices against REMOTE_QUEUE_SIZE at the top of
the loop body, before any call to get_queue_entry(). On an out-of-range
value, reset the reader register to 0 via set_queue_reader() before
breaking, so that normal queue operation can resume if the corrupted
hardware state is transient.
CVSS Score
7.1
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
dm mirror: fix integer overflow in create_dirty_log()
The argument count calculation in create_dirty_log() performs
`*args_used = 2 + param_count` before validating against argc. When a
user provides a param_count close to UINT_MAX via the device mapper
table string, this unsigned addition wraps around to a small value,
causing the subsequent `argc < *args_used` check to be bypassed.
The overflowed param_count is then passed as argc to dm_dirty_log_create(),
where it can cause out-of-bounds reads on the argv array.
Fix by comparing param_count against argc - 2 before performing the
addition, following the same pattern used by parse_features() in the
same file. Since argc >= 2 is already guaranteed, the subtraction is
safe.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
libceph: Prevent potential null-ptr-deref in ceph_handle_auth_reply()
If a message of type CEPH_MSG_AUTH_REPLY contains a zero value for both
protocol and result, this is currently not treated as an error. In case
of ac->negotiating == true and ac->protocol > 0, this leads to setting
ac->protocol = 0 and ac->ops = NULL. Thereafter, the check for
ac->protocol != protocol returns false, and init_protocol() is not
called. Subsequently, ac->ops->handle_reply() is called, which leads to
a null pointer dereference, because ac->ops is still NULL.
This patch changes the check for ac->protocol != protocol to
!ac->protocol, as this also includes the case when the protocol was set
to zero in the message. This causes the message to be treated as
containing a bad auth protocol.
CVSS Score
7.5
EPSS Score
0.005
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
KVM: SVM: Add missing save/restore handling of LBR MSRs
MSR_IA32_DEBUGCTLMSR and LBR MSRs are currently not enumerated by
KVM_GET_MSR_INDEX_LIST, and LBR MSRs cannot be set with KVM_SET_MSRS. So
save/restore is completely broken.
Fix it by adding the MSRs to msrs_to_save_base, and allowing writes to
LBR MSRs from userspace only (as they are read-only MSRs) if LBR
virtualization is enabled. Additionally, to correctly restore L1's LBRs
while L2 is running, make sure the LBRs are copied from the captured
VMCB01 save area in svm_copy_vmrun_state().
Note, for VMX, this also fixes a flaw where MSR_IA32_DEBUGCTLMSR isn't
reported as an MSR to save/restore.
Note #2, over-reporting MSR_IA32_LASTxxx on Intel is ok, as KVM already
handles unsupported reads and writes thanks to commit b5e2fec0ebc3 ("KVM:
Ignore DEBUGCTL MSRs with no effect") (kvm_do_msr_access() will morph the
unsupported userspace write into a nop).
[sean: guard with lbrv checks, massage changelog]
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ALSA: caiaq: Handle probe errors properly
The probe procedure of setup_card() in caiaq driver doesn't treat the
error cases gracefully, e.g. the error from snd_card_register() calls
snd_card_free() but continues. This would lead to a UAF for the
further calls like snd_usb_caiaq_control_init(), as Berk suggested in
another patch in the link below.
However, the problem is not only that; in general, this function drops
the all error handlings (as it's a void function) although its caller
can propagate an error to snd_probe(), which eventually calls
snd_card_free() as a proper error path. That said, we should treat
each error case in setup_card(), and just return the error code
promptly, which is then handled later as a fatal error in snd_probe().
This patch achieves it by changing the setup_card() to return an error
code. Also, the superfluous snd_card_free() call is removed, too.
Note that card->private_free can be set still safely at returning an
error. All called functions in card_free() have checks of the
unassigned resources or NULL checks.
CVSS Score
7.8
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
drm/nouveau: fix u32 overflow in pushbuf reloc bounds check
nouveau_gem_pushbuf_reloc_apply() validates each relocation with
if (r->reloc_bo_offset + 4 > nvbo->bo.base.size)
but reloc_bo_offset is __u32 (uapi/drm/nouveau_drm.h) and the integer
literal 4 promotes to unsigned int, so the addition is performed in 32
bits and wraps before the comparison against the size_t bo size.
Cast to u64 so the addition happens in 64-bit arithmetic.
[ Add Fixes: tag. - Danilo ]
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Fix conn-level packet handling to unshare RESPONSE packets
The security operations that verify the RESPONSE packets decrypt bits of it
in place - however, the sk_buff may be shared with a packet sniffer, which
would lead to the sniffer seeing an apparently corrupt packet (actually
decrypted).
Fix this by handing a copy of the packet off to the specific security
handler if the packet was cloned.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ext2: reject inodes with zero i_nlink and valid mode in ext2_iget()
ext2_iget() already rejects inodes with i_nlink == 0 when i_mode is
zero or i_dtime is set, treating them as deleted. However, the case of
i_nlink == 0 with a non-zero mode and zero dtime slips through. Since
ext2 has no orphan list, such a combination can only result from
filesystem corruption - a legitimate inode deletion always sets either
i_dtime or clears i_mode before freeing the inode.
A crafted image can exploit this gap to present such an inode to the
VFS, which then triggers WARN_ON inside drop_nlink() (fs/inode.c) via
ext2_unlink(), ext2_rename() and ext2_rmdir():
WARNING: CPU: 3 PID: 609 at fs/inode.c:336 drop_nlink+0xad/0xd0 fs/inode.c:336
CPU: 3 UID: 0 PID: 609 Comm: syz-executor Not tainted 6.12.77+ #1
Call Trace:
<TASK>
inode_dec_link_count include/linux/fs.h:2518 [inline]
ext2_unlink+0x26c/0x300 fs/ext2/namei.c:295
vfs_unlink+0x2fc/0x9b0 fs/namei.c:4477
do_unlinkat+0x53e/0x730 fs/namei.c:4541
__x64_sys_unlink+0xc6/0x110 fs/namei.c:4587
do_syscall_64+0xf5/0x220 arch/x86/entry/common.c:78
entry_SYSCALL_64_after_hwframe+0x77/0x7f
</TASK>
WARNING: CPU: 0 PID: 646 at fs/inode.c:336 drop_nlink+0xad/0xd0 fs/inode.c:336
CPU: 0 UID: 0 PID: 646 Comm: syz.0.17 Not tainted 6.12.77+ #1
Call Trace:
<TASK>
inode_dec_link_count include/linux/fs.h:2518 [inline]
ext2_rename+0x35e/0x850 fs/ext2/namei.c:374
vfs_rename+0xf2f/0x2060 fs/namei.c:5021
do_renameat2+0xbe2/0xd50 fs/namei.c:5178
__x64_sys_rename+0x7e/0xa0 fs/namei.c:5223
do_syscall_64+0xf5/0x220 arch/x86/entry/common.c:78
entry_SYSCALL_64_after_hwframe+0x77/0x7f
</TASK>
WARNING: CPU: 0 PID: 634 at fs/inode.c:336 drop_nlink+0xad/0xd0 fs/inode.c:336
CPU: 0 UID: 0 PID: 634 Comm: syz-executor Not tainted 6.12.77+ #1
Call Trace:
<TASK>
inode_dec_link_count include/linux/fs.h:2518 [inline]
ext2_rmdir+0xca/0x110 fs/ext2/namei.c:311
vfs_rmdir+0x204/0x690 fs/namei.c:4348
do_rmdir+0x372/0x3e0 fs/namei.c:4407
__x64_sys_unlinkat+0xf0/0x130 fs/namei.c:4577
do_syscall_64+0xf5/0x220 arch/x86/entry/common.c:78
entry_SYSCALL_64_after_hwframe+0x77/0x7f
</TASK>
Extend the existing i_nlink == 0 check to also catch this case,
reporting the corruption via ext2_error() and returning -EFSCORRUPTED.
This rejects the inode at load time and prevents it from reaching any
of the namei.c paths.
Found by Linux Verification Center (linuxtesting.org) with Syzkaller.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27