Linux: >> Linux Kernel >> 2.6.12.5 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
net: usb: catc: enable basic endpoint checking
catc_probe() fills three URBs with hardcoded endpoint pipes without
verifying the endpoint descriptors:
- usb_sndbulkpipe(usbdev, 1) and usb_rcvbulkpipe(usbdev, 1) for TX/RX
- usb_rcvintpipe(usbdev, 2) for interrupt status
A malformed USB device can present these endpoints with transfer types
that differ from what the driver assumes.
Add a catc_usb_ep enum for endpoint numbers, replacing magic constants
throughout. Add usb_check_bulk_endpoints() and usb_check_int_endpoints()
calls after usb_set_interface() to verify endpoint types before use,
rejecting devices with mismatched descriptors at probe time.
Similar to
- commit 90b7f2961798 ("net: usb: rtl8150: enable basic endpoint checking")
which fixed the issue in rtl8150.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
slip: bound decode() reads against the compressed packet length
slhc_uncompress() parses a VJ-compressed TCP header by advancing a
pointer through the packet via decode() and pull16(). Neither helper
bounds-checks against isize, and decode() masks its return with
& 0xffff so it can never return the -1 that callers test for -- those
error paths are dead code.
A short compressed frame whose change byte requests optional fields
lets decode() read past the end of the packet. The over-read bytes
are folded into the cached cstate and reflected into subsequent
reconstructed packets.
Make decode() and pull16() take the packet end pointer and return -1
when exhausted. Add a bounds check before the TCP-checksum read.
The existing == -1 tests now do what they were always meant to.
CVSS Score
8.2
EPSS Score
0.004
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
usb: image: mdc800: kill download URB on timeout
mdc800_device_read() submits download_urb and waits for completion.
If the timeout fires and the device has not responded, the function
returns without killing the URB, leaving it active.
A subsequent read() resubmits the same URB while it is still
in-flight, triggering the WARN in usb_submit_urb():
"URB submitted while active"
Check the return value of wait_event_timeout() and kill the URB if
it indicates timeout, ensuring the URB is complete before its status
is inspected or the URB is resubmitted.
Similar to
- commit 372c93131998 ("USB: yurex: fix control-URB timeout handling")
- commit b98d5000c505 ("media: rc: iguanair: handle timeouts")
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-08
In the Linux kernel, the following vulnerability has been resolved:
USB: core: Limit the length of unkillable synchronous timeouts
The usb_control_msg(), usb_bulk_msg(), and usb_interrupt_msg() APIs in
usbcore allow unlimited timeout durations. And since they use
uninterruptible waits, this leaves open the possibility of hanging a
task for an indefinitely long time, with no way to kill it short of
unplugging the target device.
To prevent this sort of problem, enforce a maximum limit on the length
of these unkillable timeouts. The limit chosen here, somewhat
arbitrarily, is 60 seconds. On many systems (although not all) this
is short enough to avoid triggering the kernel's hung-task detector.
In addition, clear up the ambiguity of negative timeout values by
treating them the same as 0, i.e., using the maximum allowed timeout.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-08
In the Linux kernel, the following vulnerability has been resolved:
ACPI: processor: Fix NULL-pointer dereference in acpi_processor_errata_piix4()
In acpi_processor_errata_piix4(), the pointer dev is first assigned an IDE
device and then reassigned an ISA device:
dev = pci_get_subsys(..., PCI_DEVICE_ID_INTEL_82371AB, ...);
dev = pci_get_subsys(..., PCI_DEVICE_ID_INTEL_82371AB_0, ...);
If the first lookup succeeds but the second fails, dev becomes NULL. This
leads to a potential null-pointer dereference when dev_dbg() is called:
if (errata.piix4.bmisx)
dev_dbg(&dev->dev, ...);
To prevent this, use two temporary pointers and retrieve each device
independently, avoiding overwriting dev with a possible NULL value.
[ rjw: Subject adjustment, added an empty code line ]
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-08
In the Linux kernel, the following vulnerability has been resolved:
hfsplus: pretend special inodes as regular files
Since commit af153bb63a33 ("vfs: catch invalid modes in may_open()")
requires any inode be one of S_IFDIR/S_IFLNK/S_IFREG/S_IFCHR/S_IFBLK/
S_IFIFO/S_IFSOCK type, use S_IFREG for special inodes.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
minix: Add required sanity checking to minix_check_superblock()
The fs/minix implementation of the minix filesystem does not currently
support any other value for s_log_zone_size than 0. This is also the
only value supported in util-linux; see mkfs.minix.c line 511. In
addition, this patch adds some sanity checking for the other minix
superblock fields, and moves the minix_blocks_needed() checks for the
zmap and imap also to minix_check_super_block().
This also closes a related syzbot bug report.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
atm: fore200e: fix use-after-free in tasklets during device removal
When the PCA-200E or SBA-200E adapter is being detached, the fore200e
is deallocated. However, the tx_tasklet or rx_tasklet may still be running
or pending, leading to use-after-free bug when the already freed fore200e
is accessed again in fore200e_tx_tasklet() or fore200e_rx_tasklet().
One of the race conditions can occur as follows:
CPU 0 (cleanup) | CPU 1 (tasklet)
fore200e_pca_remove_one() | fore200e_interrupt()
fore200e_shutdown() | tasklet_schedule()
kfree(fore200e) | fore200e_tx_tasklet()
| fore200e-> // UAF
Fix this by ensuring tx_tasklet or rx_tasklet is properly canceled before
the fore200e is released. Add tasklet_kill() in fore200e_shutdown() to
synchronize with any pending or running tasklets. Moreover, since
fore200e_reset() could prevent further interrupts or data transfers,
the tasklet_kill() should be placed after fore200e_reset() to prevent
the tasklet from being rescheduled in fore200e_interrupt(). Finally,
it only needs to do tasklet_kill() when the fore200e state is greater
than or equal to FORE200E_STATE_IRQ, since tasklets are uninitialized
in earlier states. In a word, the tasklet_kill() should be placed in
the FORE200E_STATE_IRQ branch within the switch...case structure.
This bug was identified through static analysis.
CVSS Score
7.5
EPSS Score
0.004
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
tcp: fix potential race in tcp_v6_syn_recv_sock()
Code in tcp_v6_syn_recv_sock() after the call to tcp_v4_syn_recv_sock()
is done too late.
After tcp_v4_syn_recv_sock(), the child socket is already visible
from TCP ehash table and other cpus might use it.
Since newinet->pinet6 is still pointing to the listener ipv6_pinfo
bad things can happen as syzbot found.
Move the problematic code in tcp_v6_mapped_child_init()
and call this new helper from tcp_v4_syn_recv_sock() before
the ehash insertion.
This allows the removal of one tcp_sync_mss(), since
tcp_v4_syn_recv_sock() will call it with the correct
context.
CVSS Score
9.8
EPSS Score
0.003
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
xfs: delete attr leaf freemap entries when empty
Back in commit 2a2b5932db6758 ("xfs: fix attr leaf header freemap.size
underflow"), Brian Foster observed that it's possible for a small
freemap at the end of the end of the xattr entries array to experience
a size underflow when subtracting the space consumed by an expansion of
the entries array. There are only three freemap entries, which means
that it is not a complete index of all free space in the leaf block.
This code can leave behind a zero-length freemap entry with a nonzero
base. Subsequent setxattr operations can increase the base up to the
point that it overlaps with another freemap entry. This isn't in and of
itself a problem because the code in _leaf_add that finds free space
ignores any freemap entry with zero size.
However, there's another bug in the freemap update code in _leaf_add,
which is that it fails to update a freemap entry that begins midway
through the xattr entry that was just appended to the array. That can
result in the freemap containing two entries with the same base but
different sizes (0 for the "pushed-up" entry, nonzero for the entry
that's actually tracking free space). A subsequent _leaf_add can then
allocate xattr namevalue entries on top of the entries array, leading to
data loss. But fixing that is for later.
For now, eliminate the possibility of confusion by zeroing out the base
of any freemap entry that has zero size. Because the freemap is not
intended to be a complete index of free space, a subsequent failure to
find any free space for a new xattr will trigger block compaction, which
regenerates the freemap.
It looks like this bug has been in the codebase for quite a long time.
CVSS Score
8.8
EPSS Score
0.005
Published
2026-05-06