Linux: >> Linux Kernel >> 4.16.12 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Limit XDomain response copy to actual frame size
tb_xdomain_copy() copies req->response_size bytes from the received
packet buffer regardless of the actual frame size. When a short
response arrives, this reads past the valid frame data in the DMA
pool buffer into stale contents from previous transactions.
Use the minimum of frame size and expected response size for the
copy length.
CVSS Score
7.1
EPSS Score
0.002
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
netfilter: require Ethernet MAC header before using eth_hdr()
`ip6t_eui64`, `xt_mac`, the `bitmap:ip,mac`, `hash:ip,mac`, and
`hash:mac` ipset types, and `nf_log_syslog` access `eth_hdr(skb)`
after either assuming that the skb is associated with an Ethernet
device or checking only that the `ETH_HLEN` bytes at
`skb_mac_header(skb)` lie between `skb->head` and `skb->data`.
Make these paths first verify that the skb is associated with an
Ethernet device, that the MAC header was set, and that it spans at
least a full Ethernet header before accessing `eth_hdr(skb)`.
CVSS Score
9.4
EPSS Score
0.004
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_fib: fix stale stack leak via the OIFNAME register
For NFT_FIB_RESULT_OIFNAME the destination register is declared with
len = IFNAMSIZ (four 32-bit registers), but on the lookup-fail,
RTN_LOCAL and oif-mismatch paths nft_fib{4,6}_eval() only writes one
register via "*dest = 0". The remaining three registers are left as
whatever was on the stack in nft_do_chain()'s struct nft_regs, and a
downstream expression that loads the register span can leak that
uninitialised kernel stack to userspace.
The NFTA_FIB_F_PRESENT existence check has the same shape: it is only
meaningful for NFT_FIB_RESULT_OIF, yet it was accepted for any result type
while the eval stores a single byte via nft_reg_store8(), leaving the rest
of the declared span stale.
Fix both:
- replace the bare "*dest = 0" in the eval with nft_fib_store_result(),
which strscpy_pad()s the whole IFNAMSIZ for OIFNAME (and is already
used on the other early-return path), and
- restrict NFTA_FIB_F_PRESENT to NFT_FIB_RESULT_OIF and declare its
destination as a single u8, so the marked span matches the one byte
the eval writes.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Clamp VBIOS HDMI retimer register count to array size
[Why & How]
The VBIOS integrated info tables (v1_11 and v2_1) contain HdmiRegNum and
Hdmi6GRegNum fields that are used as loop bounds when copying retimer I2C
register settings into fixed-size arrays (dp*_ext_hdmi_reg_settings[9]
and dp*_ext_hdmi_6g_reg_settings[3]). These u8 fields are not validated
before use, so a malformed VBIOS can specify values up to 255, causing an
out-of-bounds heap write during driver probe.
Clamp each register count to the destination array size using min_t()
before the copy loops, in both get_integrated_info_v11() and
get_integrated_info_v2_1().
(cherry picked from commit 5a7f0ef90195940c54b0f5bb85b87da55f038c69)
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-25
In the Linux kernel, the following vulnerability has been resolved:
drbd: Balance RCU calls in drbd_adm_dump_devices()
Make drbd_adm_dump_devices() call rcu_read_lock() before
rcu_read_unlock() is called. This has been detected by the Clang
thread-safety analyzer.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
fs/mbcache: cancel shrink work before destroying the cache
mb_cache_destroy() calls shrinker_free() and then frees all cache
entries and the cache itself, but it does not cancel the pending
c_shrink_work work item first.
If mb_cache_entry_create() schedules c_shrink_work via schedule_work()
and the work item is still pending or running when mb_cache_destroy()
runs, mb_cache_shrink_worker() will access the cache after its memory
has been freed, causing a use-after-free.
This is only reachable by a privileged user (root or CAP_SYS_ADMIN)
who can trigger the last put of a mounted ext2/ext4/ocfs2 filesystem.
Cancel the work item with cancel_work_sync() before calling
shrinker_free(), ensuring the worker has finished and will not be
rescheduled before the cache is torn down.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
fs/omfs: reject s_sys_blocksize smaller than OMFS_DIR_START
omfs_fill_super() rejects oversized s_sys_blocksize values (> PAGE_SIZE),
but it does not reject values smaller than OMFS_DIR_START (0x1b8 = 440).
Later, omfs_make_empty() uses
sbi->s_sys_blocksize - OMFS_DIR_START
as the length argument to memset(). Since s_sys_blocksize is u32,
a crafted filesystem image with s_sys_blocksize < OMFS_DIR_START causes
an unsigned underflow there, wrapping to a value near 2^32. That drives
a ~4 GiB memset() from bh->b_data + OMFS_DIR_START and overwrites kernel
memory far beyond the backing block buffer.
Add the corresponding lower-bound check alongside the existing upper-bound
check in omfs_fill_super(), so that malformed images are rejected during
superblock validation before any filesystem data is processed.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
PCI: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1]
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtlwifi: pci: fix possible use-after-free caused by unfinished irq_prepare_bcn_tasklet
The irq_prepare_bcn_tasklet is initialized in rtl_pci_init() and
scheduled when RTL_IMR_BCNINT interrupt is triggered by hardware.
But it is never killed in rtl_pci_deinit(). When the rtlwifi card
probe fails or is being detached, the ieee80211_hw is deallocated.
However, irq_prepare_bcn_tasklet may still be running or pending,
leading to use-after-free when the freed ieee80211_hw is accessed
in _rtl_pci_prepare_bcn_tasklet().
Similar to irq_tasklet, add tasklet_kill() in rtl_pci_deinit() to
ensure that irq_prepare_bcn_tasklet is properly terminated before
the ieee80211_hw is released.
The issue was identified through static analysis.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-24
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix use-after-free in offloaded map/prog info fill
When querying info for an offloaded BPF map or program,
bpf_map_offload_info_fill_ns() and bpf_prog_offload_info_fill_ns()
obtain the network namespace with get_net(dev_net(offmap->netdev)).
However, the associated netdev's netns may be racing with teardown
during netns destruction. If the netns refcount has already reached 0,
get_net() performs a refcount_t increment on 0, triggering:
refcount_t: addition on 0; use-after-free.
Although rtnl_lock and bpf_devs_lock ensure the netdev pointer remains
valid, they cannot prevent the netns refcount from reaching zero.
Fix this by using maybe_get_net() instead of get_net(). maybe_get_net()
uses refcount_inc_not_zero() and returns NULL if the refcount is already
zero, which causes ns_get_path_cb() to fail and the caller to return
-ENOENT -- the correct behavior when the netns is being destroyed.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-06-24