Linux: >> Linux Kernel >> 6.12.58 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
spi: sprd: fix error pointer deref after DMA setup failure
The driver falls back to PIO mode if DMA setup fails during probe.
Make sure to check the dma.enabled flag before trying to release the DMA
channels also on late probe errors to avoid dereferencing an error
pointer (or attempting to release a channel a second time).
This issue was flagged by Sashiko when reviewing a devres allocation
conversion patch.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
ipv6: ioam: refresh hdr pointer before ioam6_event()
Reported by Sashiko:
In ipv6_hop_ioam(), the hdr pointer is initialized to point into the
skb's linear data buffer. Later, the code calls skb_ensure_writable(),
which might reallocate the buffer:
if (skb_ensure_writable(skb, optoff + 2 + hdr->opt_len))
goto drop;
/* Trace pointer may have changed */
trace = (struct ioam6_trace_hdr *)(skb_network_header(skb)
+ optoff + sizeof(*hdr));
ioam6_fill_trace_data(skb, ns, trace, true);
ioam6_event(IOAM6_EVENT_TRACE, dev_net(skb->dev),
GFP_ATOMIC, (void *)trace, hdr->opt_len - 2);
If the skb is cloned or lacks sufficient linear headroom,
skb_ensure_writable() will invoke pskb_expand_head(), which reallocates
the skb's data buffer and frees the old one, invalidating pointers to
it. While the code recalculates the trace pointer immediately after the
call to skb_ensure_writable(), it fails to recalculate the hdr pointer.
This patch fixes the above by recalculating the hdr pointer before
passing hdr->opt_len to ioam6_event(), so that we avoid any UaF.
CVSS Score
9.8
EPSS Score
0.005
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
ALSA: asihpi: Fix potential OOB array access at reading cache
find_control() to retrieve a cached info accesses the array with the
given index blindly, which may lead to an OOB array access.
Add a sanity check for avoiding it.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
ALSA: pcm: Don't setup bogus iov_iter for silencing
At transition to the iov_iter for PCM data transfer, we blindly
applied the iov_iter setup also for silencing (i.e. data = NULL), and
it leads to a calculation of bogus iov_iter. Fortunately this didn't
cause troubles on most of architectures but it goes wrong on RISC-V
now, causing a NULL dereference.
Handle the NULL data case to treat the silencing in interleaved_copy()
for addressing the bug above. noninterleaved_copy() has already the
NULL data handling, so it doesn't need changes.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/adm1266) widen blackbox-info buffer to I2C_SMBUS_BLOCK_MAX
adm1266_nvmem_read_blackbox() declares a 5-byte stack buffer and
passes it to i2c_smbus_read_block_data() to retrieve the 4-byte
BLACKBOX_INFO response. i2c_smbus_read_block_data() does not honour
caller buffer sizes -- it memcpy()s data.block[0] bytes from the
SMBus transaction (where data.block[0] is the length byte returned by
the slave device, up to I2C_SMBUS_BLOCK_MAX = 32):
memcpy(values, &data.block[1], data.block[0]);
If the device returns any block length above 5, the call overflows
the caller's 5-byte stack buffer before the post-call
if (ret != 4)
return -EIO;
check has a chance to reject the response.
Widen the local buffer to I2C_SMBUS_BLOCK_MAX so the helper has room
for any well-formed SMBus block response, matching the convention used
by the other i2c_smbus_read_block_data() callers in this driver.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
smb: client: require net admin for CIFS SWN netlink
CIFS_GENL_CMD_SWN_NOTIFY is the userspace witness-notify command. The
intended sender is the cifs.witness helper, but the generic-netlink
operation currently has no capability flag, so any local process can send
RESOURCE_CHANGE or CLIENT_MOVE notifications to the in-kernel witness
handler.
The same family exposes CIFS_GENL_MCGRP_SWN without multicast-group
capability flags. Register messages sent to that group include the witness
registration id and, for NTLM-authenticated mounts, the username, domain,
and password attributes copied from the CIFS session. An unprivileged
local process should not be able to join that group and receive those
messages.
Require CAP_NET_ADMIN for incoming SWN_NOTIFY commands with
GENL_ADMIN_PERM, and require CAP_NET_ADMIN over the network namespace for
joining the SWN multicast group with GENL_MCAST_CAP_NET_ADMIN. The
cifs.witness service runs with the privileges needed for both operations.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
net: bcmgenet: keep RBUF EEE/PM disabled
Setting RBUF_EEE_EN | RBUF_PM_EN in RBUF_ENERGY_CTRL breaks the RX
path on GENET hardware once MAC EEE becomes active. RX traffic stops
flowing while the link stays up and the usual descriptor/RX error
counters remain quiet. In that state the MAC still accepts frames
(rbuf_ovflow_cnt keeps climbing) but RBUF no longer forwards them to
DMA, so rx_packets is no longer incremented at the netdev level. On
some boards the corruption ends up as a paging fault in
skb_release_data via bcmgenet_rx_poll on an LPI exit.
Reproduced on Pi 4B (BCM2711 + BCM54213PE) and confirmed by Florian
Fainelli on an internal Broadcom 4908-family board with the same crash
signature. RBUF_PM_EN is not publicly documented.
This shows up more often now that phy_support_eee() enables EEE by
default, but it also affects older kernels as soon as TX LPI is
turned on via ethtool, so it is not specific to recent changes.
Always clear RBUF_EEE_EN | RBUF_PM_EN in bcmgenet_eee_enable_set so
the bits stay off across resets. UMAC and TBUF setup is left alone so
TX-side EEE keeps working.
CVSS Score
9.8
EPSS Score
0.006
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: MGMT: validate Add Extended Advertising Data length
MGMT_OP_ADD_EXT_ADV_DATA is registered as a variable-length command,
with MGMT_ADD_EXT_ADV_DATA_SIZE as the fixed header size. The handler
then uses cp->adv_data_len and cp->scan_rsp_len to validate and copy
cp->data, but it never checks that those bytes are part of the mgmt
command payload.
A short command can therefore make add_ext_adv_data() pass an
out-of-bounds pointer into tlv_data_is_valid(). If the bytes beyond
the command buffer are addressable, they can also be copied into the
advertising instance as scan response data, where the caller can read
them back via MGMT_OP_GET_ADV_INSTANCE. The trigger requires
CAP_NET_ADMIN in the initial user namespace; KASAN reports an 8-byte
slab-out-of-bounds read.
Reject commands whose length does not match the fixed header plus both
advertising data lengths before parsing cp->data.
CVSS Score
7.3
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: ecred_reconfigure: send packed pdu, not stack pointer
Commit 1c08108f3014 ("Bluetooth: L2CAP: Avoid -Wflex-array-member-not-at-end
warnings") converted the on-stack request PDU in l2cap_ecred_reconfigure()
from an explicit packed struct to DEFINE_RAW_FLEX(), but did not adjust the
size and source-pointer arguments to l2cap_send_cmd():
- struct {
- struct l2cap_ecred_reconf_req req;
- __le16 scid;
- } pdu;
+ DEFINE_RAW_FLEX(struct l2cap_ecred_reconf_req, pdu, scid, 1);
...
l2cap_send_cmd(conn, chan->ident, L2CAP_ECRED_RECONF_REQ,
sizeof(pdu), &pdu);
After the conversion, DEFINE_RAW_FLEX() expands to declare an anonymous
union pdu_u plus a local pointer "pdu" pointing at it. Therefore:
- sizeof(pdu) is now sizeof(struct l2cap_ecred_reconf_req *) = 8 on
64-bit (4 on 32-bit), not the 6 bytes of (mtu, mps, scid[1]).
- &pdu is the address of the local pointer's stack storage, not the
address of the request payload.
l2cap_send_cmd() forwards (data, count) to l2cap_build_cmd(), which calls
skb_put_data(skb, data, count). The L2CAP_ECRED_RECONFIGURE_REQ packet
body therefore contains 8 bytes copied from the kernel stack starting at
&pdu -- the 8 bytes overlap the pdu pointer's value, leaking a kernel
stack address to the paired Bluetooth peer. The intended (mtu, mps, scid)
fields are not transmitted at all, so the peer rejects the request as
malformed and the L2CAP_ECRED_RECONFIGURE feature itself has been broken
for the local-side initiator since the introducing commit landed.
The sibling site l2cap_ecred_conn_req() in the same commit was converted
correctly (sizeof(*pdu) + len, pdu); only this site was missed.
Restore the original semantics: pass the full flex-struct size via
struct_size(pdu, scid, 1) and the pdu pointer (the struct address) as
the source.
Validated on a stock 7.0-based host kernel via the real call path:
setsockopt(SOL_BLUETOOTH, BT_RCVMTU, ...) on a BT_CONNECTED
L2CAP_MODE_EXT_FLOWCTL socket emits an L2CAP_ECRED_RECONFIGURE_REQ
whose body is 8 bytes (the on-stack pdu local's value) rather than
the expected 6. Three captures from fresh socket / fresh hciemu peer
on the same host -- low bytes vary per call, high 0xffff confirms a
kernel virtual address (KASLR-randomised stack slot, not a fixed
string):
RECONF_REQ body (ident=0x02 len=8): 42 fb 54 af 0e ca ff ff
RECONF_REQ body (ident=0x02 len=8): 52 3d 2e af 0e ca ff ff
RECONF_REQ body (ident=0x02 len=8): b2 fc 5b af 0e ca ff ff
After this patch the body is 6 bytes carrying the expected
little-endian (mtu, mps, scid).
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-19
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: ISO: drop ISO_END frames received without prior ISO_START
ISO data PDUs carry a packet-boundary flag indicating START, CONT, END
or SINGLE. The ISO_CONT branch of iso_recv() guards against a missing
ISO_START by checking conn->rx_len before touching conn->rx_skb, but
ISO_END does not.
If a peer sends an ISO_END as the first packet on a fresh ISO
connection, conn->rx_skb is still NULL and conn->rx_len is zero, so
skb_put(conn->rx_skb, ...) dereferences NULL and oopses. For BIS,
where receivers sync to a broadcaster without pairing, any broadcaster
on the air can trigger this.
Mirror the ISO_CONT check at the top of ISO_END so a stray end fragment
is logged and dropped instead of crashing the host.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-19